| 查看: 1114 | 回复: 3 | ||||||
yshit木虫 (小有名气)
|
[交流]
反应磁控溅射相关文献 已有3人参与
|
|
两篇2005年Thin Solid Films，一篇2000年Surface and Coatings Technology Sproul, W.D., D.J. Christie and D.C. Carter, Control of reactive sputtering processes. Thin Solid Films, 2005. 491(1–2): p. 1-17. 1. Introduction. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 2. Flow control of the reactive gas . . . . . . .. . . . . . . . . . . . . . 2 3. Partial pressure control of the reactive gas . . . . . . . . . . . . . . . . . . . . . . 3 4. Comparison of mass flow and partial pressure controlled hysteresis curves .. . . . . . 6 5. Power for reactive sputtering of insulating films . .. . . . . . . . . . . . . . . . 9 6. Reactive gas activation and distribution . . . . . . . . . . . . . . . . 12 7. Other approaches to reactive sputtering . . . . . . . . . . . . . . . . . . 13 8. Dual magnetron reactive co-sputtering . . . . . . . . . . . . . . . . . . . 13 9. Two-gas reactive sputtering . . . . . . . . . . . . . . . . . . . . . . . . . . 13 10. Small area reactive sputtering . . . . . . . . . . . . . . . . . . . 15 Musil, J., et al., Reactive magnetron sputtering of thin films: present status and trends. Thin Solid Films, 2005. 475(1–2): p. 208-218. This paper gives a critical review of the present state of the knowledge in the field of dc reactive magnetron sputtering of compound films.It analyses (i) the hysteresis effect and the methods of its elimination, (ii) problem of stability of reactive sputtering and (iii) deposition of transparent oxides in the transition mode of sputtering. It shows the conditions under which oxides are reactively sputtered with high deposition rates aD oxide achieving up to approximately 77% of that of a pure metal aD Me , i.e. a D oxide/a D Mec0.77. A special attention is devoted to the elimination of arcing in sputtering of insulating films using pulsed dual magnetron or sputtering of oxides from a substoichiometric target. Also, the ion bombardment of films growing on insulating or unbiased substrates in dc pulsed magnetron sputtering is discussed in detail. As an example, a new possibility to form superhard single-phase films based on solid solutions using dc reactive magnetron sputtering is shown. At the end, future trends in dc reactive magnetron sputtering are outlined. Safi, I., Recent aspects concerning DC reactive magnetron sputtering of thin films: a review. Surface and Coatings Technology, 2000. 127(2–3): p. 203-218. In this paper, attention is paid to DC reactive magnetron sputtering and its implications, such as the hysteresis effect and the instability in the reactive gas pressure, differential poisoning of magnetron cathode, as well as the methods which are used to control the process. These methods include: a. increasing the pumping speed, which requires considerable additional costs; b.increasing the target-to-substrate distance, which requires larger vacuum chambers hence, higher costs. and also results in lower deposition rates; c. obstructing reactive gas flow to the cathode with the resultant reduction of deposition rate and the need for complicated arrangements; d. pulsed reactive gas flow, which requires an extensive amount of process optimisation and a continuous monitoring and adjustment of the process parameters; e. plasma emission monitoring; and f. voltage control, which are inexpensive and have proved to be powerful techniques for monitoring and controlling the reactive sputtering processes, in real time without disturbing the discharge, for the deposition of high-quality films, reproducibly. In addition, arcing and methods to avoid it are reviewed; this includes, arc initiations and their destructive effects e.g. driving the process to become unstable,reducing the target lifetime and creating defects in the sputtered films., time required for arcs to occur, and finally, methods of avoiding arcs. The latter includes the use of unipolar or bipolar pulsing techniques at frequencies in the range 10-70 kHz The reactive DC-Magnetron Sputtering 介绍了反应磁控溅射的原理，相关溅射参数，以及沉积系统。 Process[ Last edited by yshit on 2013-4-23 at 15:13 ] |
回复此楼» 本帖附件资源列表
-
欢迎监督和反馈：小木虫仅提供交流平台，不对该内容负责。
本内容由用户自主发布，如果其内容涉及到知识产权问题，其责任在于用户本人，如对版权有异议，请联系邮箱：xiaomuchong@tal.com - 附件 1 : Controlofreactivesputteringprocesses.pdf
- 附件 2 : Reactivemagnetronsputteringofthinfilmspresentstatusandtrends.pdf
- 附件 3 : RecentaspectsconcerningDCreactivemagnetronsputteringofthinfilmsareview.pdf
- 附件 4 : ThereactiveDC-MagnetronSputteringProcess.pdf
2013-04-22 16:25:34, 461.68 K
2013-04-22 16:25:37, 361.54 K
2013-04-22 16:25:39, 1.13 M
2013-04-22 16:25:41, 157.81 K
» 收录本帖的淘帖专辑推荐
 薄膜材料 | 反应磁控溅射 | 杂化太阳能电池进展 |
» 猜你喜欢
一志愿中国海洋大学，生物学，301分，求调剂
已经有6人回复
-
081700化工学硕调剂
已经有3人回复
-
材料学硕318求调剂
已经有4人回复
-
329求调剂
已经有4人回复
-
一志愿吉林大学材料学硕321求调剂
已经有11人回复
-
一志愿苏州大学材料求调剂，总分315（英一）
已经有3人回复
-
0703化学调剂
已经有14人回复
-
320求调剂0856
已经有3人回复
-
307求调剂
已经有9人回复
-
288求调剂
已经有15人回复
» 本主题相关价值贴推荐，对您同样有帮助:
- 氧化物半导体迁移率低----室温反应磁控溅射
已经有17人回复
- 磁控溅射换靶材之后功率变化很大？
已经有8人回复
- [求助]磁控溅射制备SiN，用的是射频电源，有辉光，但溅射不上
已经有11人回复
- 磁控溅射&离子溅射
已经有11人回复
- 射频磁控溅射ZAO陶瓷靶时遇到的一些问题
已经有10人回复
- 请教各位虫友，AlN薄膜耐强碱腐蚀吗？
已经有15人回复
- 反应磁控溅射自偏压太高是问什么？
已经有5人回复
- 磁控溅射能起辉，但不能沉积
已经有21人回复
- 开个帖子，关于CIGS太阳能电池的，有问必答，欢迎交流
已经有115人回复
- 求助：反应磁控溅射制备氮化铬薄膜，靶电源用DC还是RF好呢？
已经有9人回复
- 磁控溅射做薄膜失败了吗
已经有21人回复
- 射频磁控溅射镀膜都可以通入哪些气体
已经有11人回复
- 求助关于磁控溅射的问题
已经有29人回复
- 磁控溅射镀ZnO，大家真空度一般抽到多少？
已经有18人回复
- 磁控溅射与反应磁控溅射
已经有18人回复
- 我用磁控溅射镀的硼膜，是这个样子的，请问高手们是什么原因，该怎么办？
已经有9人回复
- 磁控溅射镀氧化铝
已经有35人回复
- EQCM使用求助 紧急求助 在线等
已经有11人回复
- 【求助】磁控反应溅射一短时间后怎么老是腔里面会怕的一声响
已经有7人回复
- 【求助】磁控溅射仪相关
已经有8人回复
2楼2013-04-23 11:05:27
Mike_Fu
金虫 (小有名气)
少将
- 应助: 4 (幼儿园)
- 金币: 1242.6
- 帖子: 62
- 在线: 63.5小时
- 虫号: 1270986
- 注册: 2011-04-20
- 性别: GG
- 专业: 金属材料的制备科学与跨学
3楼2013-06-13 18:30:17
ggtech
铁虫 (小有名气)
- 应助: 1 (幼儿园)
- 金币: 1576.9
- 帖子: 171
- 在线: 90.2小时
- 虫号: 2118722
- 注册: 2012-11-10
- 性别: GG
- 专业: 无机非金属类光电信息与功
4楼2013-06-15 19:22:20
