关于防腐环氧树脂涂层的阻抗值过低的情况!
目前本人有一篇文章被拒了,有两个审稿人都提到了,说我的阻抗值很低。
原话如下:
If the coating is not conductive coating, the convincing value of coating impedance need to be above 10E8 <OMEGA> for the barrier coating, while given EIS results show that the maximum value of coating impedance does not exceed 10E6 <OMEGA>.
In general, the impedance modulus of the epoxy resin cured with polyamide 650 is relative high (~10E10 <OMEGA> cm2).
但是我做的测试,和同学做的测试结果来看,一般环氧树脂的阻抗值只有几百KΩ,根本达不到审稿人说的阻抗值,请问是什么原因啊?@langzhizhou@Gamry-电化学 返回小木虫查看更多
今日热帖
自顶一个!!!
我测过漆,没单独测树脂,我的漆测出来刚开始起码在10E7以上,你的树脂喷的多厚,一般越厚数值越大
我做的涂层一般是在25微米左右
求求各位大神不吝赐教啊!!!
自己测的不好使,关键要有文献依据才行啊
您一般做的阻抗值有多少数量级呢
,