24小时热门版块排行榜    

北京石油化工学院2026年研究生招生接收调剂公告
查看: 1232  |  回复: 2
当前只显示满足指定条件的回帖,点击这里查看本话题的所有回帖

1987lengxin

银虫 (正式写手)

[求助] ((sinθ)/λ)max, A–1 在cif 中可以找到吗? 代表什么值?

哪个大侠知道晶体数据 ((sinθ)/λ)max, A–1 在哪可以找到?代表什么意思?

[ Last edited by 1987lengxin on 2011-7-9 at 10:56 ]
回复此楼

» 收录本帖的淘帖专辑推荐

单晶解析

» 猜你喜欢

» 本主题相关价值贴推荐,对您同样有帮助:

点滴在心间
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

gy

至尊木虫 (正式写手)

http://journals.iucr.org/services/cif/checking/THETM_01.html

PROC-NAME: THETM01 Type_3

PURPOSE: To check that _diffrn_reflns_theta_max is greater than expected limits.

PROCEDURE:
CALCULATE

S = SIN [_diffrn_reflns_theta_max] / _diffrn_radiation_wavelength

TEST

IF S < 0.55 issue ALERT A
   "Alert A The value of sine(theta_max)/wavelength is less than 0.550"
< 0.575 issue ALERT B
   "Alert B The value of sine(theta_max)/wavelength is less than 0.575"
< 0.59 issue ALERT C
   "Alert C The value of sine(theta_max)/wavelength is less than 0.590"
The Commission on Journals has determined that setting the maximum sin(theta)/lambda for measurements to at least 0.6 is both optimal and achievable for most structural studies. The extent of the data not only affects the ratio of measurements to refined parameters and hence the accuracy of the atomic and geometric parameters, but also the reliability of the angular dependent terms, such as Uijs.
It is unlikely that any submitted CIF which contains the results of a data collection with a lower theta(max) will be accepted for publication unless there are exceptional circumstances. Old data claimed to have been collected when less stringent criteria were in place will not be excepted.

You should routinely set your diffractometer so that a theta(max) of 25 deg. for Mo radiation or 67 deg. for Cu radiation is the minimum that is achieved. If the crystal diffracts sufficiently well, it is strongly recommended that theta(max) is set to an even higher value.

It is understood that there may be little point in collecting background "noise" when a weakly diffracting crystal gives no detectable diffraction above theta values well below our required limit. In such a case, you should first ensure that you have conscientiously undertaken all possible steps to ensure that the experiment has been able to extract the best diffracting power from your sample. To this end, all of the following options should have been exhausted:

(a) The best possible crystal has been sought and utilised for the data collection. If the crystal was small or of poor quality, are you sure that a better or bigger one cannot be obtained? The chosen crystal may have been the best one in the batch, but had enough effort and patience really been expended in the crystallisation attempt? Often, lack of experience, impatience or unwillingness to try another crystallisation technique or solvent leads to the experimentalist abandoning crystallisation attempts before the optimal conditions have been found. Before you blame the crystal quality, be sure that you have convinced yourself that nothing further can be done in this direction.

(b) Use low temperature measurements to enhance the reflection intensities and the extent of the "observed" data.

(c) For organic compounds, try data collection with Cu radiation, which significantly enhances the reflection intensities.
3楼2013-07-16 15:02:59
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖
查看全部 3 个回答

gy

至尊木虫 (正式写手)

S = SIN [_diffrn_reflns_theta_max] / _diffrn_radiation_wavelength
2楼2013-07-16 15:02:10
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖
最具人气热帖推荐 [查看全部] 作者 回/看 最后发表
[考研] 材料求调剂 +10 呢呢妮妮 2026-04-01 10/500 2026-04-04 23:12 by 无际的草原
[考研] 一志愿沪9,求生物学调剂,326分 +6 刘墨墨 2026-04-04 6/300 2026-04-04 19:44 by 唐沐儿
[论文投稿] 求文献 5+3 ys879651$ 2026-04-02 3/150 2026-04-04 17:22 by bobvan
[考研] 一志愿0817化学工程与技术,求调剂 +24 我不是只因 2026-04-02 28/1400 2026-04-04 15:15 by dongzh2009
[考研] 复试调剂 +6 范根培 2026-04-04 6/300 2026-04-04 14:27 by 土木硕士招生
[考研] 334求调剂 +8 曾仰之 2026-04-03 8/400 2026-04-04 11:16 by w_xuqing
[考研] 0710生物学336分求调剂 +6 kiyy 2026-04-01 8/400 2026-04-04 10:10 by kiyy
[考研] 材料调剂 +11 吴棂颖! 2026-04-03 11/550 2026-04-04 09:56 by 小小树2024
[考研] 调剂 +5 asdasdassda 2026-04-03 6/300 2026-04-03 20:27 by 岸上的一条鱼
[考研] 327求调剂 +9 小卡不卡. 2026-03-29 9/450 2026-04-03 19:48 by 百灵童888
[基金申请] esi高被引论文是不是能对中标有所加分和帮助呢 +5 redcom 2026-04-01 6/300 2026-04-03 15:15 by Howard28
[考研] 085600专硕材料与化工348分求调剂 +10 上学啦! 2026-04-01 11/550 2026-04-03 14:13 by 百灵童888
[考研] 一志愿武汉理工0856,初试334 +3 26考研材料 2026-04-02 3/150 2026-04-02 21:22 by dongzh2009
[考研] 085602化学工程268分蹲调剂 +8 月照花林。 2026-04-01 8/400 2026-04-01 22:08 by 无际的草原
[考研] 环境工程调剂 +9 hyzzzzzzz. 2026-04-01 9/450 2026-04-01 14:20 by salamander`
[考研] 08工科,295,接受跨专业调剂 +6 lmnlzy 2026-03-31 6/300 2026-04-01 11:02 by 逆水乘风
[考研] 一志愿北京科技大学085601材料工程英一数二初试总分335求调剂 +5 双马尾痞老板2 2026-03-31 5/250 2026-04-01 09:04 by oooqiao
[考研] 土木304求调剂 +5 顶级擦擦 2026-03-31 5/250 2026-04-01 08:15 by fdcxdystjk¥
[考研] 一志愿浙江大学工科动力工程370,数一121,专业课135,现在能去哪里 +3 080700调剂 2026-03-30 4/200 2026-03-31 12:00 by KLMY666
[考博] 材料专业申博 +5 杜雨婷dyt 2026-03-29 5/250 2026-03-31 11:19 by oooqiao
信息提示
请填处理意见