| 查看: 1231 | 回复: 2 | |||
1987lengxin银虫 (正式写手)
|
[求助]
((sinθ)/λ)max, A–1 在cif 中可以找到吗？ 代表什么值？
|
|
哪个大侠知道晶体数据 ((sinθ)/λ)max, A–1 在哪可以找到？代表什么意思？ [ Last edited by 1987lengxin on 2011-7-9 at 10:56 ] |
回复此楼» 收录本帖的淘帖专辑推荐
 单晶解析 |
» 猜你喜欢
【2026 考研调剂】哈尔滨工程大学核科学与技术学院核化工系 招收调剂生
已经有1人回复
-
广州大学环境大分子材料研究所2026年研究生招生简章
已经有0人回复
-
无机化学论文润色/翻译怎么收费?
已经有118人回复
-
武汉纺织大学技术研究院招收化学、生物、材料、纺织、机械等专业调剂生
已经有0人回复
-
台州学院有序多孔材料团队化学、材料与化工硕士招生，请速联系！
已经有0人回复
-
首都师范大学化学系田洋课题组专硕招调剂生
已经有10人回复
-
广州大学大湾区环境研究院环境大分子材料研究所王平山教授团队 2026年研究生招生简章
已经有0人回复
-
广州大学大湾区环境研究院环境大分子材料研究所王平山教授团队 2026年研究生招生简章
已经有0人回复
-
天津理工大学
已经有0人回复
» 本主题相关价值贴推荐，对您同样有帮助:
- 请帮我处理A、B 类错误
已经有9人回复
- 关于晶体结构解析中的A、B类错误的解决办法
已经有4人回复
- 求高手帮我解决我的check cif
已经有3人回复
- checkcif检查出来有A,B,C,G类错误
已经有4人回复
- 我的CIF好多A.B类错误 求高手帮忙看下是哪些原因
已经有5人回复
- CIF的A类错误处理求助
已经有6人回复
- 请各位大侠帮忙处理一下晶体A ,B类错误，谢谢
已经有8人回复
- 有谁能帮忙解决几个A类B类错误，急急急！
已经有13人回复
- 多个A类错误，求帮助
已经有3人回复
- 【交流】常见A、B类错误及解决办法大收集
已经有61人回复
- 【请教】本人菜鸟一个，请教几个A类错误
已经有7人回复
- 【求助】CIF文件中有A. B. C. G. 类错误，想请坛里的高手帮忙精修一下！
已经有3人回复
gy
至尊木虫 (正式写手)
- 应助: 41 (小学生)
- 金币: 11295.7
- 散金: 2289
- 红花: 9
- 帖子: 423
- 在线: 692.2小时
- 虫号: 21895
- 注册: 2003-08-28
- 性别: GG
- 专业: 生物大分子结构与功能
2楼2013-07-16 15:02:10
gy
至尊木虫 (正式写手)
- 应助: 41 (小学生)
- 金币: 11295.7
- 散金: 2289
- 红花: 9
- 帖子: 423
- 在线: 692.2小时
- 虫号: 21895
- 注册: 2003-08-28
- 性别: GG
- 专业: 生物大分子结构与功能
|
http://journals.iucr.org/services/cif/checking/THETM_01.html PROC-NAME: THETM01 Type_3 PURPOSE: To check that _diffrn_reflns_theta_max is greater than expected limits. PROCEDURE: CALCULATE S = SIN [_diffrn_reflns_theta_max] / _diffrn_radiation_wavelength TEST IF S < 0.55 issue ALERT A "Alert A The value of sine(theta_max)/wavelength is less than 0.550" < 0.575 issue ALERT B "Alert B The value of sine(theta_max)/wavelength is less than 0.575" < 0.59 issue ALERT C "Alert C The value of sine(theta_max)/wavelength is less than 0.590" The Commission on Journals has determined that setting the maximum sin(theta)/lambda for measurements to at least 0.6 is both optimal and achievable for most structural studies. The extent of the data not only affects the ratio of measurements to refined parameters and hence the accuracy of the atomic and geometric parameters, but also the reliability of the angular dependent terms, such as Uijs. It is unlikely that any submitted CIF which contains the results of a data collection with a lower theta(max) will be accepted for publication unless there are exceptional circumstances. Old data claimed to have been collected when less stringent criteria were in place will not be excepted. You should routinely set your diffractometer so that a theta(max) of 25 deg. for Mo radiation or 67 deg. for Cu radiation is the minimum that is achieved. If the crystal diffracts sufficiently well, it is strongly recommended that theta(max) is set to an even higher value. It is understood that there may be little point in collecting background "noise" when a weakly diffracting crystal gives no detectable diffraction above theta values well below our required limit. In such a case, you should first ensure that you have conscientiously undertaken all possible steps to ensure that the experiment has been able to extract the best diffracting power from your sample. To this end, all of the following options should have been exhausted: (a) The best possible crystal has been sought and utilised for the data collection. If the crystal was small or of poor quality, are you sure that a better or bigger one cannot be obtained? The chosen crystal may have been the best one in the batch, but had enough effort and patience really been expended in the crystallisation attempt? Often, lack of experience, impatience or unwillingness to try another crystallisation technique or solvent leads to the experimentalist abandoning crystallisation attempts before the optimal conditions have been found. Before you blame the crystal quality, be sure that you have convinced yourself that nothing further can be done in this direction. (b) Use low temperature measurements to enhance the reflection intensities and the extent of the "observed" data. (c) For organic compounds, try data collection with Cu radiation, which significantly enhances the reflection intensities. |
3楼2013-07-16 15:02:59
