24小时热门版块排行榜

返回列表

当前只显示满足指定条件的回帖，点击这里查看本话题的所有回帖

robot121

铜虫 (小有名气)

应助: 0 (幼儿园)
金币: 732.3
帖子: 57
在线: 43.5小时
虫号: 780603

[交流] 虫友们给看看审稿人的意见，还有机会吗？

虫友们，帮忙看看审稿人的意见，看看是否有机会中哦！谢谢！
Reviewers' comments:

The paper reports the structure and properties of (AlCrMnMoNiZrB0.1)Nx coatings. These multielement coatings are rather new and original. However the quality of the paper needs to be improved. Please see the following comments:

1. Grammar errors occur throughout the paper; English needs to be improved. Some errors are even technical.
Just to name a few:
P3, L10       XRD stands for "X-ray Diffraction", not "X-ray diffractometer".
P3, L12       Surface morphology is typically "observed" instead of "obtained".
P8, L8       Verb is mssing in this sentence.
P8, L9       This while sentence is ambiguous.
Please perform a thorough check and have native speaker check your English.

2. The Boron content in your target should be only 1.64 at.%. But the EPMA results suggest that the alloy film have a B content of ~9 at.%. This is almost six times higher than that in the target and is very unusual. How did this happen? Did you check the composition of your target? Note that even in the nitride films the B content is still much higher than it should be.

3. The authors claim that the peak in deposition rate at Rn=0.5 is due to re-sputtering of Al atoms. However, unlike your ref. 20, there is no Al deficient in your alloy film. Therefore there is no apparent re-sputtering of Al in your film and this reason does not make sense.

4. P6, final line.
"bombardment by energetic discharge species led to a relatively strong re-sputtering effect", please provide some reference for this statement.

5. Can you provide more discussion regarding the tribological properties of the films? Particularly why the friction coefficient is so low relative to other multi-element nitride films.

Additions of the editor:
-the accuracy of the method of Scherrer to determine the crystallite size is only about 10%. Consequently, the results of this technique cannot be presented with more than two digits. Values in the manuscript should be rounded off. Please, note that "crystallite" is a better term than "grain".
-The research highlights should be appropriate for stand-alone reading so every symbol should be explicitly defined.

回复此楼