24小时热门版块排行榜    

查看: 369  |  回复: 7
当前主题已经存档。

clwang

木虫 (正式写手)

[交流] 帮下忙

ITO薄膜作为PTCDA/Si--有机/无机光电探测器的阳极时,衬底材料为不耐高温的有机物,ITO薄膜需在低温下淀积。本文通过射频磁控溅射在玻璃衬底表面淀积ITO透明导电薄膜,通过四探针和紫外可见-近红外光谱试仪分别测量薄膜的导电性、透光率。实验结果表明:随着溅射过程压力的升高,薄膜的透过率和电阻率都会逐渐变差;随着溅射功率的增大,薄膜的电阻率会变好但是透过率会变差;氧气分压的增加虽然在一定程度上有助于薄膜透过率的提高,同时导致薄膜的电阻率的增加;但对薄膜进行高温下的退火则会很好的降低薄膜的电阻率。结论:在低温下制备ITO薄膜的优化工艺条件为:溅射气压为0.45Pa,功率为45W,溅射时以氧气作为反应气体,不需对成品器件进行退火处理。

» 猜你喜欢

努力,努力,再努力。
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

wangkt

木虫 (正式写手)

★ ★ ★ ★ ★
clwang(金币+5,VIP+0):非常感谢关注 8-10 20:02
顶一下,类似的问题见过,楼主搜一下
2楼2009-08-10 10:54:09
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

clwang

木虫 (正式写手)

大家帮帮忙

如题,大家帮帮忙,急用
努力,努力,再努力。
3楼2009-08-10 15:42:55
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

wangkt

木虫 (正式写手)

When ITO membrane as anode of PTCDA/Si--organic\inorganic photoelectricity detector,underlay  materials are organic which don't apply to hight temperature,ITO membrane need to illuviation under low temperature .This paper use the radio
抱歉专业词汇太多了,翻译不好了,明天再翻
4楼2009-08-11 01:18:20
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

monitor2885

至尊木虫 (职业作家)

队长

★ ★
clwang(金币+2,VIP+0): 8-11 09:21
有时间看看
Retirement
5楼2009-08-11 09:02:56
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

monitor2885

至尊木虫 (职业作家)

队长

★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
zap65535(金币+29,VIP+0):补发 12-23 13:22
zap65535(金币+4,VIP+0):补发 12-23 13:22
When ITO thin film is taken as PTCDA/Si-- organic/inorganic photodetector anode, the substrate material is organic substance that can not withstand high temperature. ITO thin film deposition at low temperature is required. In this paper, RF magnetron sputtering on glass substrate surface is used to deposit ITO transparent conductive film. Then, through four-point probe and ultraviolet visible near-infrared spectroscopy measurement are applied to test conductivity and light transmission rate. The experimental results show that with the increasing pressure in sputtering process, film transmittance and resistivity will gradually deteriorate. While as sputtering power increases, resistivity of thin film will become a good performance but transmittance deteriorated. However, the increase in oxygen partial pressure to some extent, can contribute to improvement of transmittance, at the same time lead resistivity of film increases. But under high-temperature film annealing will reduce resistivity greatly.
Retirement
6楼2009-08-11 16:19:38
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

monitor2885

至尊木虫 (职业作家)

队长

done

Conclusion: under low temperature optimized conditions for preparation of ITO film are as follows: sputtering pressure of 0.45Pa, power of 45W, oxygen as reactive gas when sputtering, negligible annealing treatment for finished devices.
Retirement
7楼2009-08-11 16:21:32
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

smithnancy

银虫 (正式写手)

还有一个快捷的方法就是,找篇相似的文献,按照人家的句式结构改改,最好找英美本土作者的。
8楼2009-08-12 13:46:24
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖
相关版块跳转 我要订阅楼主 clwang 的主题更新
普通表情 高级回复 (可上传附件)
信息提示
请填处理意见