24小时热门版块排行榜    

Znn3bq.jpeg
查看: 925  |  回复: 6
本帖产生 1 个 翻译EPI ,点击这里进行查看
当前只显示满足指定条件的回帖,点击这里查看本话题的所有回帖

wyjjf

新虫 (正式写手)

[求助] 可以这样用英语表达吗?谢谢

The up end of the dashed lines corresponds to the inclination angles that the ship shifted again
上端对应的倾斜角度是船体再次倾斜的角度

g is the original centre of gravity of the liquid, and  G is the new centre of gravity of the liquid.

The repaired compartments with some water
这样表达可以吗?

【图标题】@90, @82, @30 and @1.5 are the longitudinalcoordinates of four sections of hull

The force was programmed increase at an average of 10 KN
编辑程序时,设定力以10kn 递增

In the calculation of ****, calculation of the maximum shear force is important and that of the state of ship on the water and load distribution.
在计算过程中,计算最大剪力是重要的,船体在水面的状态和载荷分布也是重要的

The mistake was corrected and marked in red inrevised paper.

【翻译】桌面是朝上的

Then the ***** process of the four cases were simulated.
接下来模拟了四个案例的****过程
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

mac194

铁虫 (职业作家)

【答案】应助回帖

原句:
  The mistake was corrected and marked in red in revised paper.
更好:
  Mistakes previously pointed out by the reviewer (Thank you!!) have been corrected and marked in red in re-submitted copy of the paper


桌面是朝上的
  The table stands upright

  The table's top surface faces up
4楼2015-10-14 18:39:43
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖
查看全部 7 个回答

ssssllllnnnn

至尊木虫 (知名作家)

Translator and Proofreader


【答案】应助回帖

★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★ ★
wyjjf: 金币+15, 翻译EPI+1, ★★★★★最佳答案 2015-10-21 07:57:42
The up end of the dashed lines corresponds to the inclination angles that the ship shifted again.【可以】
上端对应的倾斜角度是船体再次倾斜的角度

g is the original centre of gravity of the liquid, and  G is the new centre of gravity of the liquid.
【可试用】
g and G are the original and new centers of gravity of the liquid, respectively.

The repaired compartments with some water
这样表达可以吗?【表、图题可以】

【图标题】@90, @82, @30 and @1.5 are the longitudinal coordinates of four sections of hull 【可】

The force was programmed TO increase at an average of 10 KN
编辑程序时,设定力以10kn 递增 【加to】

In the calculation of ****, calculation of the maximum shear force is important and that of the state of ship on the water and load distribution.
在计算过程中,计算最大剪力是重要的,船体在水面的状态和载荷分布也是重要的
【可试用】
In the calculation of ****, calculation of the maximum shear force is important, so are the state of ship on the water and load distribution.

The mistake was corrected and marked in red in revised paper.

【翻译】桌面是朝上的

Then the ***** process of the four cases were simulated. 【were 改为was】
接下来模拟了四个案例的****过程
2楼2015-10-14 09:10:49
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

mac194

铁虫 (职业作家)

【答案】应助回帖

提醒:
  不要随便相信  "__头衔__"  者进言, 币多不代表博闻

建议:
      学我按 "浮力中心" 临时找
  https://slideplayer.com/slide/4318707/
      或
  https://slideplayer.com/slide/4318497/   [看图]

更正:
  The repaired compartments with some water 不行, 因为毫无意义
    For stability, fill unpaired compartments with ballast  也许更合原意

  The up end of...  不对, 该是  upper end  或  top end

  state of ship on the water... 不对,
    the ship's physical condition (shape, load distribution, etc) above water surface
更达意
----------------
可以这样用英语表达吗?谢谢
Center of Buoyancy  浮力中心.jpg

3楼2015-10-14 18:21:27
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

mac194

铁虫 (职业作家)

【答案】应助回帖

桌面是朝上的
  The table stands upright
更明确:
  The table's top surface points up (towards the ceiling)
5楼2015-10-14 18:45:16
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖
最具人气热帖推荐 [查看全部] 作者 回/看 最后发表
[考博] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 qs8kylt1wr 2026-05-01 3/150 2026-05-03 06:34 by jmr1kibhvw
[博后之家] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +4 d8tbypao1q 2026-05-01 4/200 2026-05-03 05:49 by w5idbsc3mz
[找工作] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 d8tbypao1q 2026-05-01 3/150 2026-05-03 05:07 by jmr1kibhvw
[公派出国] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 d8tbypao1q 2026-05-01 4/200 2026-05-03 05:04 by jmr1kibhvw
[论文投稿] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 d8tbypao1q 2026-05-01 4/200 2026-05-03 03:49 by w5idbsc3mz
[考研] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 k17zww5nna 2026-05-01 4/200 2026-05-03 03:19 by w5idbsc3mz
[公派出国] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 k17zww5nna 2026-05-01 4/200 2026-05-03 03:04 by w5idbsc3mz
[博后之家] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +4 k17zww5nna 2026-05-01 4/200 2026-05-03 02:06 by w5idbsc3mz
[找工作] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +4 k17zww5nna 2026-05-01 5/250 2026-05-03 01:49 by w5idbsc3mz
[找工作] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +4 qs8kylt1wr 2026-05-01 4/200 2026-05-03 00:00 by 火炎焱燚炙烤
[论文投稿] 有人投过CCC中国控制会议吗? 19+3 初九凡 2026-04-26 4/200 2026-05-02 21:11 by Equinoxhua
[考博] 考博 +4 Eternitf 2026-04-29 4/200 2026-05-02 16:10 by yejenny
[公派出国] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 qs8kylt1wr 2026-05-01 3/150 2026-05-02 15:51 by zahslv263y
[考博] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 qs8kylt1wr 2026-05-01 3/150 2026-05-02 15:51 by zahslv263y
[论文投稿] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 qs8kylt1wr 2026-05-01 3/150 2026-05-02 15:21 by zahslv263y
[博后之家] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 qs8kylt1wr 2026-05-01 3/150 2026-05-02 15:06 by zahslv263y
[教师之家] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 k17zww5nna 2026-05-01 3/150 2026-05-02 09:36 by dz7y1p1i98
[硕博家园] 售SCI一区T0P文章,我:8.O.5.5.1.O.5.4,科目齐全,可+急 +3 k17zww5nna 2026-05-01 5/250 2026-05-02 09:21 by dz7y1p1i98
[文学芳草园] 太白金星有点烦 +3 yexuqing 2026-04-27 3/150 2026-04-30 21:56 by myrtle
[论文投稿] 有没有快的中文核心比较快录用的,纳米材料光催化 5+3 2914439618 2026-04-27 4/200 2026-04-29 08:59 by 北京莱茵润色
信息提示
请填处理意见