| 查看: 879 | 回复: 6 | ||
| 【奖励】 本帖被评价4次，作者alwens增加金币 3.5 个 | ||
| 当前主题已经存档。 | ||
[资源]
关于QSAR模型的评价
|
||
|
在QSAR中一般对线性回归模型的回归或预测性能会用相关系数R进行评价，对于初学者应注意评价模型优劣的用词，一般4个常用的描述性词汇（poor，fair，good，excellent）有对应的量化指标，如使用不当容易引起审稿人的反感。 ps: 除了相关系数，还应该同时考虑所得到模型的截距（应接近0）和斜率（应接近1），有文章使用下表中的标准，仅供参考。 Ranking of results according to the correlation indexes： Index Excellent Good Fair Poor ----------------------------------------------------------------------------- R 1.00-0.90 0.89-0.80 0.79-0.50 <0.50 Slope 1.00-0.90 0.89-0.80 0.79-0.50 <0.50 Intercept 0.00-0.10 0.11-0.20 0.20-0.50 >0.50 [ Last edited by alwens on 2008-1-17 at 16:30 ] |
回复此楼» 猜你喜欢
瑞典林雪平大学博士后招聘｜PEC Water Splitting 方向
已经有130人回复
-
PRB投稿，Acknowledgment sent to author状态十天了
已经有3人回复
-
物理学I论文润色/翻译怎么收费?
已经有86人回复
-
PVA溶解
已经有2人回复
-
基金申请
已经有44人回复
-
CSC与新西兰维多利亚大学PhD奖学金项目
已经有0人回复
-
新西兰Robinson研究所 招聘CSC公派访问人员
已经有0人回复
-
帮我的英语口语老师找学生
已经有0人回复
-
什么时候开奖？
已经有6人回复
-
散金币祈福
已经有94人回复
★★★★★ 五星级,优秀推荐
★
lei0736(金币+1,VIP+0):多谢积极参与讨论
lei0736(金币+1,VIP+0):多谢积极参与讨论
|
好像回归性是用R来评价的 预测性还不行吧， 除了R和交差验证R，还有一些其它指标。 下面是qsar鼻祖Hansch做的QSAR后，对其方程进行评价的内容： Validation of the QSAR Models QSAR model validation is an essential task in developing a statistically valid and predictive model, because the real utility of a QSAR model is in its ability to predict accurately the modeled property for new compounds. The following approaches have been used for the validation of QSAR Eqs. 1–20: • Fraction of the variance: The fraction of the variance of an MRA model is expressed by r2. It is believed that the closer the value of r2 to unity, the better the QSAR model. The values of r2 for these QSAR models are from 0.787 to 0.993, which suggests that these QSARmodels explain 78.7–99.3% of the variance of the data. According to the literature, the predictive QSAR model must have r2 > 0.6 [73, 74]. • Cross-validation test: The values of q2 for these QSAR models are from 0.549 to 0.972. The high values of q2 validate the QSAR models. From the literature, it must be greater than 0.50 [73, 74]. • Standard deviation (s): s is the standard deviation about the regression line. The smaller the value of s the better the QSAR model. The values of s for these QSAR models are from 0.065 to 0.406. • Quality factor or quality ratio (Q): The high values of Q (2.259–14.646) for these QSAR models suggest that the high predictive power for these models as well as no over-fitting. • Fischer statistics (F): Fischer statistics (F) is the ratio between explained and unexplained variance for a given number of degree of freedom. The larger the F value the greater the probability that the QSAR equation is significant. The F values obtained for these QSAR models are from 17.622 to 283.714, which are statistically significant at the 95% level. • All the QSAR models (except Eqs. 7 and 9) also fulfill the thumb rule condition that (number of data points)/(number of descriptors) ≥ 4. |
2楼2008-02-01 22:00:59
3楼2008-02-24 22:22:47
4楼2008-05-20 10:40:26
