| 查看: 305 | 回复: 1 | |||
| 当前主题已经存档。 | |||
| 本帖产生 1 个 翻译EPI ，点击这里进行查看 | |||
[交流]
求助 英语错误 帮忙改正
|
|||
|
The molten zone was very stable for the entire duration of the growth procedure. The power needed to melt the rods was about 55％ of the total output power of the lamps. However, there is a problem that a large number of bubble inclusions observed in a crystal grown at 10 mm/h with the rotation rate of 30 rpm as shown in Fig. 2(a). In other systems, the same situations were mentioned, and to suppress the bubble inclusion, Seok Gyu Yoon increased the melt temperature, M. HiguchiS et al. used a higher rotation rate and M. Koohpayeh et al. [20] turned rotation rate down to 0 rpm.. In our later work, lower rotation rates of 10 and 5 were applied and the as-grown crystals were denoted as simple 1 and simple 2, respectively. The crystal wafers from simple 1 and simple 2 cut perpendicular to the growth direction and fine polished were detected with polarizing microscope. There are few bubble inclusions in the sample 1 as shown in Fig. 2(b). And Fig. 2(c) shows that the sample 2 is free of bubble inclusion. In all case, no low-angle grain boundary is observed. In conclusion, the as-grown zo crystals are free of bubble inclusion and low-angle grain boundary and a lower rotation rate is effective to suppress the formation of bubble inclusion in growth of zo crystal. 最好 标上颜色 ，不胜感激 |
回复此楼» 猜你喜欢
售SCI-T0P文章，我:8O.5.5.1.O.54,科目齐全,可+急
已经有3人回复
-
考博求助
已经有3人回复
-
售SCI一区文章，我:8.O.551.O.5.4,科目全,可伽急
已经有5人回复
-
售SCI一区T0P文章，我:8.O.55.1.O.5.4,科目全,可+急
已经有4人回复
-
售SCI一区T0P文章，我:8.O.55.1.O.5.4,科目全,可+急
已经有5人回复
-
售SCI-T0P文章，我:8O.5.5.1.O.54,科目齐全,可+急
已经有9人回复
-
售一区SCI文章T0P，我:8O.551.O54,科目全,可十急
已经有9人回复
-
售SCI一区T0P文章，我:8.O.55.1.O.5.4,科目全,可+急
已经有10人回复
-
售SCI一区文章，我:8.O.551.O.5.4,科目全,可伽急
已经有6人回复
-
售SCI一区T0P文章，我:8O.55.1.O.54,科目全,可伽急
已经有9人回复
xinyunsina
金虫 (小有名气)
- 翻译EPI: 4
- 应助: 0 (幼儿园)
- 金币: 861.5
- 散金: 183
- 帖子: 130
- 在线: 9.8小时
- 虫号: 683859
- 注册: 2008-12-29
- 性别: GG
- 专业: 情报学
★ ★
sirljz(金币+2, 翻译EPI+1):够认真，谢谢交流，欢迎常来 2010-04-05 13:10
lliang921(金币+20): 2010-04-16 08:50
sirljz(金币+2, 翻译EPI+1):够认真，谢谢交流，欢迎常来 2010-04-05 13:10
lliang921(金币+20): 2010-04-16 08:50
| The molten zone was very stable for the entire duration of the growth procedure. The power needed to melt the rods accounted for about 55％ of the total output power of the lamps. However, there was a problem that a large number of bubble inclusions were observed in a crystal grown at 10 mm/h with the rotation rate of 30 rpm as shown in Fig. 2(a). In other systems, similar situations were also mentioned. To suppress the bubble inclusion, Seok Gyu Yoon increased the melt temperature, M. HiguchiS et al. used a higher rotation rate and M. Koohpayeh et al. [20] turned rotation rate down to 0 rpm.. In our later work, lower rotation rates of 10 and 5 were applied and the as-grown crystals were denoted as simple 1 and simple 2, respectively. The crystal wafers from simple 1 and simple 2 cut perpendicular to the growth direction and fine polished ? were detected with polarizing microscope. There are few bubble inclusions in the sample 1 as shown in Fig. 2(b). And Fig. 2(c) shows that the sample 2 is free of bubble inclusion. In all cases, no low-angle grain boundary is observed. In conclusion, the as-grown zo crystals are free of bubble inclusion and low-angle grain boundary ; a lower rotation rate is effective to suppress the formation of bubble inclusion in growth of zo crystal. |
2楼2010-04-05 10:48:34
