| 查看: 175 | 回复: 0 | |||
| 当前主题已经存档。 | |||
nandhutu金虫 (正式写手)
|
[交流]
翻译求助
|
||
| Pin profiling is done by developing the relation between the width of the sheet/film and the width of the flow channel in the Feedblock., i.e., if the flow channel is 4'' wide and the untrimmed sheet width is 50'', then each .080 in the Feedblock corresponds to an inch in the sheet and relates to the same position relative to the centre of the sheet. Following this reasoning, it can be determined where the slot machining is required. It is not unusual in fine tuning for layer uniformity, to have to remachine the pin more than once. |
回复此楼» 猜你喜欢
售SCI-T0P文章，我:8O.5.5.1.O.54,科目齐全,可+急
已经有3人回复
-
考博求助
已经有3人回复
-
售SCI一区文章，我:8.O.551.O.5.4,科目全,可伽急
已经有5人回复
-
售SCI一区T0P文章，我:8.O.55.1.O.5.4,科目全,可+急
已经有4人回复
-
售SCI一区T0P文章，我:8.O.55.1.O.5.4,科目全,可+急
已经有5人回复
-
售SCI-T0P文章，我:8O.5.5.1.O.54,科目齐全,可+急
已经有9人回复
-
售一区SCI文章T0P，我:8O.551.O54,科目全,可十急
已经有9人回复
-
售SCI一区T0P文章，我:8.O.55.1.O.5.4,科目全,可+急
已经有10人回复
-
售SCI一区文章，我:8.O.551.O.5.4,科目全,可伽急
已经有6人回复
-
售SCI一区T0P文章，我:8O.55.1.O.54,科目全,可伽急
已经有9人回复
10