24小时热门版块排行榜    

查看: 177  |  回复: 3
当前主题已经存档。

liulan110

新虫 (正式写手)

[交流] 求助翻译!

请帮忙翻译以下文字:Their impedance was determined by altering the current passing through the cell in a stepwise manner while simultaneously recording the voltage at the cell’s terminals (gal-vanostatic regime) and subsequently subjecting pulses of current and voltage to a Fourier transform。
     As the setup ensured a voltage compensation at the terminals, the relative error of measurements was reduced to  0.1%.When taking measurements, the capacity of each cell diminished by no greater than 0.05% of the nominal value. To reduce the effect of the passive film at the lithium anode, a “pulse” of current (up to 900 s in length,amplitude 50 mA) was passed through the cell before taking each measurement. After each measurement the cell was discharged by short-circuiting it across a 0.3–0.32-kohm resistor. The discharge time was ~24 h. The impedance characteristics were monitored after each discharge, without applying the preliminary “pulse.”After storing the cells for 80 days, their impedance characteristics were determined once again, but now each discharge cycle alters the passive film more than using the preliminary current pulse.

» 猜你喜欢

已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

johnl

银虫 (正式写手)

大哥,你的悬赏少了点。
2楼2009-09-17 12:39:50
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

wojinjin

金虫 (小有名气)

★ ★ ★ ★
liulan110(金币+4,VIP+0):谢谢 9-20 09:52
我们可以通过逐步改变通过电池的电流的方法来确定阻抗,同时记录电池两端的电压。接下来对电流和电压的脉冲进行傅里叶变换。
       因为我们的装置可以保证电池两端的电压补偿,所以测量误差减少到0.1%,每个电池的电容减少的不到面值的0.05%。为了减少锂阳极处钝化膜的影响,在每次测量之前都要先在电池中通一下电流脉冲(脉冲长达90s,幅度是50 mA),每次测量之后都要通过一个0.3–0.32千欧的电阻进行短路放电。放电时间大约是24小时。每次放电后测量阻抗的特性,不要用原来用过的那种脉冲来测。把电池存放80天后,在对电池的特性进行测定,这种情况下改变钝化膜的情形远比用当初用的电流脉冲的效果好。

注:我不知道你这里面的cell是不是翻译成电池。。。呵呵
活着要不断的进步。。。。
3楼2009-09-17 14:52:21
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

lixiaod001

金虫 (正式写手)

★ ★
liulan110(金币+2,VIP+0):谢谢了 9-20 09:52
他们的阻抗测定改变电流通过细胞在逐步地同时记录了电压细胞的接线端子,随后明明的脉冲电流和电压到傅里叶变换。
  为确保了电压补偿设置在码头,相对误差减至0.1%.When测量的能力以测量,每个细胞减少不超过0.05%的名义价值。减少的效果在锂阳极钝化膜,”的脉搏(900在长度、振幅50 mA)是通过细胞之前,每个测试。每个测试后的细胞被排出的短路过0.3 - 0.32-kohm电阻。这个放电状态时间是~ 24小时。之后的阻抗特性进行了监测每次排放,没有申请的初步”脉冲。”后的细胞为80天内储存的阻抗特性,确定,但现在再一次改变了每个流量循环使用钝化膜的初步的电流脉冲。
4楼2009-09-18 09:42:26
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖
相关版块跳转 我要订阅楼主 liulan110 的主题更新
普通表情 高级回复 (可上传附件)
信息提示
请填处理意见