| 查看: 175 | 回复: 3 | |||
| 当前主题已经存档。 | |||
[交流]
求助翻译!
|
|||
|
请帮忙翻译以下文字:Their impedance was determined by altering the current passing through the cell in a stepwise manner while simultaneously recording the voltage at the cell’s terminals (gal-vanostatic regime) and subsequently subjecting pulses of current and voltage to a Fourier transform。 As the setup ensured a voltage compensation at the terminals, the relative error of measurements was reduced to 0.1%.When taking measurements, the capacity of each cell diminished by no greater than 0.05% of the nominal value. To reduce the effect of the passive film at the lithium anode, a “pulse” of current (up to 900 s in length,amplitude 50 mA) was passed through the cell before taking each measurement. After each measurement the cell was discharged by short-circuiting it across a 0.3–0.32-kohm resistor. The discharge time was ~24 h. The impedance characteristics were monitored after each discharge, without applying the preliminary “pulse.”After storing the cells for 80 days, their impedance characteristics were determined once again, but now each discharge cycle alters the passive film more than using the preliminary current pulse. |
» 猜你喜欢
假如你的研究生提出不合理要求
已经有8人回复
萌生出自己或许不适合搞科研的想法,现在跑or等等看?
已经有4人回复
Materials Today Chemistry审稿周期
已经有4人回复
参与限项
已经有3人回复
实验室接单子
已经有4人回复
全日制(定向)博士
已经有4人回复
对氯苯硼酸纯化
已经有3人回复
求助:我三月中下旬出站,青基依托单位怎么办?
已经有12人回复
所感
已经有4人回复
要不要辞职读博?
已经有7人回复
2楼2009-09-17 12:39:50
wojinjin
金虫 (小有名气)
- 应助: 0 (幼儿园)
- 金币: 1144.9
- 散金: 20
- 帖子: 250
- 在线: 31.9小时
- 虫号: 814077
- 注册: 2009-07-22
- 性别: MM
- 专业: 凝聚态物性 II :电子结构
★ ★ ★ ★
liulan110(金币+4,VIP+0):谢谢 9-20 09:52
liulan110(金币+4,VIP+0):谢谢 9-20 09:52
|
我们可以通过逐步改变通过电池的电流的方法来确定阻抗,同时记录电池两端的电压。接下来对电流和电压的脉冲进行傅里叶变换。 因为我们的装置可以保证电池两端的电压补偿,所以测量误差减少到0.1%,每个电池的电容减少的不到面值的0.05%。为了减少锂阳极处钝化膜的影响,在每次测量之前都要先在电池中通一下电流脉冲(脉冲长达90s,幅度是50 mA),每次测量之后都要通过一个0.3–0.32千欧的电阻进行短路放电。放电时间大约是24小时。每次放电后测量阻抗的特性,不要用原来用过的那种脉冲来测。把电池存放80天后,在对电池的特性进行测定,这种情况下改变钝化膜的情形远比用当初用的电流脉冲的效果好。 注:我不知道你这里面的cell是不是翻译成电池。。。呵呵 |

3楼2009-09-17 14:52:21
★ ★
liulan110(金币+2,VIP+0):谢谢了 9-20 09:52
liulan110(金币+2,VIP+0):谢谢了 9-20 09:52
|
他们的阻抗测定改变电流通过细胞在逐步地同时记录了电压细胞的接线端子,随后明明的脉冲电流和电压到傅里叶变换。 为确保了电压补偿设置在码头,相对误差减至0.1%.When测量的能力以测量,每个细胞减少不超过0.05%的名义价值。减少的效果在锂阳极钝化膜,”的脉搏(900在长度、振幅50 mA)是通过细胞之前,每个测试。每个测试后的细胞被排出的短路过0.3 - 0.32-kohm电阻。这个放电状态时间是~ 24小时。之后的阻抗特性进行了监测每次排放,没有申请的初步”脉冲。”后的细胞为80天内储存的阻抗特性,确定,但现在再一次改变了每个流量循环使用钝化膜的初步的电流脉冲。 |
4楼2009-09-18 09:42:26












回复此楼