| 查看: 283 | 回复: 2 | |||
| 当前主题已经存档。 | |||
WHQ197木虫 (正式写手)
|
[交流]
请高手帮忙校对摘要
|
||
|
为了探索电流体动力学干燥机理,优化干燥工艺,提高干燥效率,通过采用针电极、线电极和板电极在不同的电压下对豆腐进行了干燥速度对比实验,同时进行了针电极下豆腐加玻璃罩与不加罩的干燥速度对比实验和豆腐的高压电场预处理实验。实验结果表明:采用板电极干燥效果不明显,而采用线电极和针电极能获得较大的干燥速度,加玻璃罩后豆腐的干燥速度远低于未加罩豆腐,高压电场预处理并不能提高豆腐的干燥速度,最后分析了电流体动力学干燥机理,认为离子风对被干燥物料的冲击作用是导致其干燥速度增加的主要原因。 In order to explore the mechanism, improve the drying efficiency of Electrohydrodynamic (EHD) drying, contrast experiments of drying rate on tofu using a needle electrode, a wire electrode and a plate electrode under different voltages have been evaluated in this study, respectively. At the same time, the contrast experiment of drying rate on tofu using a needle electrode with and without glass enclosures and the drying rate of the tofu pretreated by the high electric field was investigated. The results indicate high voltage electric field formed by a plate electrode that cannot improve the drying rate obviously, while a needle electrode and a wire electrode can improve the drying rate significantly, the drying rate of tofu with plus glass enclosures is much lower than that without glass enclosures, the high electric field pretreatment could not increase the drying rate of the tofu and it is thought that it is corona wind produced by the electrode, which resembles a round jet , impinges and removes moisture from the tofu surface. |
» 猜你喜欢
全日制(定向)博士
已经有5人回复
假如你的研究生提出不合理要求
已经有10人回复
萌生出自己或许不适合搞科研的想法,现在跑or等等看?
已经有4人回复
Materials Today Chemistry审稿周期
已经有4人回复
参与限项
已经有3人回复
实验室接单子
已经有4人回复
对氯苯硼酸纯化
已经有3人回复
求助:我三月中下旬出站,青基依托单位怎么办?
已经有12人回复
所感
已经有4人回复
要不要辞职读博?
已经有7人回复
monitor2885
至尊木虫 (职业作家)
队长
- 翻译EPI: 15
- 应助: 6 (幼儿园)
- 贵宾: 0.339
- 金币: 38700.5
- 散金: 147
- 红花: 22
- 帖子: 4943
- 在线: 2166.8小时
- 虫号: 701577
- 注册: 2009-02-15
- 性别: GG
- 专业: 生态系统生态学
★ ★ ★ ★ ★ ★ ★ ★
WHQ197(金币+8,VIP+0):谢谢提供帮助 7-8 08:09
WHQ197(金币+8,VIP+0):谢谢提供帮助 7-8 08:09
|
Contrast experiments of drying rate on tofu applying needle electrode, wire electrode and plate electrode under different voltages were measured, respectively, in order to explore mechanism, optimizing process and improve drying efficiency of Electrohydrodynamic (EHD).Meanwhile, The contrast experiment of drying rate on tofu using needle electrode with glass enclosure and counterpart without it, were investigated, as well as high electric field pretreatment. The results indicated that plate electrode was not desired, while high drying rate was obtained with needle and wire electrodes. Then drying rate of tofu fitted with glass enclosure showed slower than that one without it. High electric field pretreatment failed to improve drying rate. Finally, drying mechanism about EHD was analyzed. The concussion impact of corona wind on target was the main reason to increase drying rate. *不要总用the;状语从句后置;长句不要过多;语态多为过去时 |

2楼2009-07-06 10:07:35
★ ★ ★ ★ ★ ★ ★
WHQ197(金币+7,VIP+0):感谢帮助 7-8 08:10
WHQ197(金币+7,VIP+0):感谢帮助 7-8 08:10
|
The purpose of this paper was to explore the mechanism of EHD drying, to optimize the drying process, and to improve the drying efficiency. In experiments, bean curd (tofu) drying rate was comparatively measured by needle electrodes, wire electrodes and plate electrodes at different voltages. At the same time, High voltage electric field pretreatment experiments and drying rate experiments were performed on bean curd under the needle electrode with and with out glass cover. The results showed that the drying effect of the electrode plate was not obvious. Use wire electrode and needle electrode can obtain better drying rate. The drying rate of bean curd with glass cover is much lower than that without glass cover. High voltage electric field pretreatment cannot increase the drying rate of bean curd. At last, the EHD drying mechanism was analyzed. The impact of ion wind on the drying material played a major role to increase drying rate. [ Last edited by cloisonne on 2009-7-6 at 12:09 ] |
3楼2009-07-06 12:04:32












回复此楼