| 查看: 211 | 回复: 3 | |||
| 当前主题已经存档。 | |||
[交流]
【求助完毕】求助翻译····谢谢谢谢
|
|||
|
求助··谁能帮我翻译下面纯英文的说明书哦···谢谢谢谢啦 Crease on Weft straightener 1.movement of skew roller may cause crease. 2.Direction of bow roller may cause crease. Normally,Weft straightener correct skew and bow distortion to use distance between GUIDE ROLL and SWING ROLL as like above picture. Cloth is fed according to slanted direction of SKEW ROLL or BOW ROLLER,in this time,crease may happen.And crease will different from angle of SWING ROLL or EXPANDER(BOW) ROLL.Therefore,cloth(expang and contract,slip),position of roller and strength of driving are may causes crease. If crease show up due to different of tension,In this case,it is not regular tension,And,tension will repeat tight and loose.In such a case,crease will happen because roller is bent or interlock is incorrect. I found under mentioned problem in test-run. 1.Tension of cylinder was very high. 2.Roller spin was irregular. 3.Fishtail of feeding cloth very big. For removing crease,SKEW ROLL must little act.In the case of bow distortion,BOW ROLLER is positioned by manual operation at the point where is not happen crease. It can complementto move frelly(smoothly) SKEW ROLLER,but in this case,tension of feeding cloth is should soft and regular. And,once happen crease due to tension,it may show up crease after STENTER also.So,T think that you'd better install BOW ROLLER at rear part of weft straightener in purpose of removing crease which is happened in the course of correction of skew and bow distortion. [ Last edited by qingshaojun0823 on 2009-9-22 at 15:46 ] |
回复此楼» 猜你喜欢
计算机11408，286分求调剂
已经有4人回复
-
0703化学321分求调剂
已经有17人回复
-
材料与化工371求调剂
已经有10人回复
-
一志愿 江南大学 085602 化工专硕 338分求调剂
已经有6人回复
-
22408 总分320，一篇论文二作，两个国三，求调剂
已经有3人回复
-
277求调剂
已经有3人回复
-
考研生物学考A区211，初试322，科目生化和生物综合，求调剂
已经有6人回复
-
求调剂
已经有3人回复
-
285求调剂
已经有6人回复
-
材料求调剂
已经有3人回复
2楼2009-06-27 02:24:38
3楼2009-06-28 10:20:11
 |
4楼2009-08-24 12:14:29
