| 查看: 615 | 回复: 0 | |||
zjrfs银虫 (小有名气)
|
[求助]
请教一种微缺口机械加工技术
|
请教虫友们一个机械加工方面的问题，我在文献中看到了一种razor micro-notching的技术，好像可以给金属加工切口，而且切口根部非常窄，就是几微米。下面是关于这种技术的几段英文描述，哪位了解这种技术请多多指教，不胜感激 1、The notches were sharpened by a micro-notching procedure involving polishing at the root of the notch with a razor blade, which was irrigated with a 1 μm diamond suspension, to give a final crack length of ao ~ 1.8–2.6 mm (0.41 ≤ ao/W ≤ 0.60) with a reproducible root radius of 3–5 μm. 2、Samples were then taken from locations longitudinal or transverse to the bone long axis, and notched to form an initial crack of roughly half the sample width, which was then sharpened with a micronotching technique using a razor blade irrigated with a 1 μmdiamond suspension. 3、The notches were first introduced using a low-speed diamond saw, and then sharpened using a razor micro-notching technique. Micro-notches, with root radius ~3-5 μm, were obtained by repeatedly sliding a razor blade over the saw-cut notch using a custom-made rig, while continually irrigating with a 1 μm diamond slurry. 4、‘razor micro-notching’, where polishing with a razor blade at the root of a notch is used to produce a machined slot (i.e. with no crack closure and little damage ahead of the tip) with a root radius smaller than the characteristic microstructural dimensions (10 um). |
回复此楼» 猜你喜欢
力学研究所某专项团队支撑岗位和特别研究助理岗位招聘启事
已经有10人回复
-
7075材料过滤难
已经有0人回复
-
金属材料论文润色/翻译怎么收费?
已经有274人回复
-
生物流体博士后 (Simulation, Experiment, and Scientific Machine Learning)
已经有1人回复
-
达姆施塔特市中心好房出租
已经有52人回复
-
散尽家财，祈求中标。
已经有190人回复
-
国自然预计9月中才会给资助
已经有20人回复
-
哎，豆包分析我的面上1A3B1C
已经有0人回复
-
两篇一区，一篇二区想寻找南京地区的学校
已经有0人回复
-
是遇到投稿系统bug了吗
已经有19人回复
-
英国拉夫堡大学-CSC（国家留学基金）奖学金招收2027/2028学年博士
已经有0人回复