| 查看: 299 | 回复: 3 | |||
| 当前主题已经存档。 | |||
yinn2008金虫 (小有名气)
|
[交流]
急求翻译！！！请大家帮忙！可以分段译
|
||
|
1.电热水器保温层----无氟聚氨酯整体发泡技术 该技术利用全自动高压发泡机把整机所需要的保温材料聚醚多元醇和异氰酸脂(俗称白料和黑料，比例：1.05：1)注入产品中，在内胆与外壳之间形成一层保温层，以确保热水器良好的保温效果。发泡密度：24～29kg/m³ ，发泡厚达40—60mm 该技术能够实现长时间保温的效果，美的热水器的水温每小时温度下降仅有0.5-1度，冬天保温可长达36小时，夏天保温可长达72小时。 2.加热管----长达1米 我司产品加热管，为超长加粗不锈钢加热管。结构从外至内依次是：英格莱800不锈钢管，耐高温绝缘氧化镁粉，高频电阻丝三层结构。美的加热棒耐温高达1357-1385°C 加热管出厂检测作用是用来加热内胆中的水，要求使用寿命长，加热效率高，不得漏电。 ①:外观要求：焊接良好，无明显变形，裂痕，毛刺。 ②:绝缘 ：1000V，2S, ≥20MΩ ③:耐压：1800V，3S，≤5mA 3.温控器 当内胆水温加热超过75°C以后，通过感温元件测温控制自动切断电源, 当水温下降到某一温度时,又自动接通电源，使热水器水温保持在设定值, 确保热水器始终有热水供应。温度调节范围为30~75°C。 4.温控器 如果万一调温器损坏失效，水温继续升高，当达到限温器设定温度时（我公司定为105℃），限温器动作，切断电源，起到防干烧、防超温的保护作用。待排除故障后，只能手动按钮使其复位，才能继续使用。 ①: 性能要求：要求限制温度范围在105（-8-+5）℃必须断开。 ②：寿命要求：通电寿命＞5000次。 ③: 电气安全；在带电端子与绝缘部队间施加1800V、５０Hz,整定电流为５mA的交流电压下持续１min，应无击穿或闪络现象 在同极端子间（OFF状态），施加800V、50Hz,整定电流为5mA的交流电压下持续1min，应无击穿或闪络现象。 |
回复此楼» 猜你喜欢
298求调剂
已经有5人回复
-
272求调剂
已经有4人回复
-
285求调剂
已经有6人回复
-
材料调剂
已经有4人回复
-
面上模板改不了页边距吧？
已经有6人回复
-
307求调剂
已经有6人回复
-
304求调剂
已经有5人回复
-
317一志愿华南理工电气工程求调剂
已经有8人回复
-
272求调剂
已经有3人回复
-
化工专硕348，一志愿985求调剂
已经有6人回复
mnbbnm123
铁杆木虫 (正式写手)
- 翻译EPI: 11
- 应助: 0 (幼儿园)
- 金币: 12280.6
- 红花: 2
- 帖子: 860
- 在线: 177.2小时
- 虫号: 311927
- 注册: 2006-12-30
- 性别: GG
- 专业: 有机合成
2楼2009-03-11 10:48:33
yinn2008
金虫 (小有名气)
- 应助: 0 (幼儿园)
- 金币: 800.6
- 帖子: 135
- 在线: 16.1小时
- 虫号: 152697
- 注册: 2006-01-02
- 性别: MM
- 专业: 环境污染化学
3楼2009-03-11 11:26:33
★ ★ ★ ★ ★ ★
yinn2008(金币+6,VIP+0):辛苦了 3-12 20:25
yinn2008(金币+6,VIP+0):辛苦了 3-12 20:25
|
1.Insulation layer of electric water heater---- overall fluorine-free polyurethane foam technology The technology uses fully automatic high-pressure foaming machine to inject machine needed insulation materials-- Polyether alcohols and isocyanate (commonly known as white material and black material, the ratio: 1.05:1) into the Product, forming a layer of insulation laye in the liner and the shell , to ensure good thermal insulation effect of the water heater. Foam density: 24 ~ 29kg / m³, foam 40-60mm thick. The technology can achieve the effect of prolonged heat, the temperature of the Meidi water heater asure drop of only 0.5-1℃ per hour, the winter thermal insulation for up to 36 hours, the summer heat for up to 72 hours. 2.Heating tubes ---- up to 1 m Products Division my heating pipes, as long bold stainless steel heating tubes. Structure from the outside to inside are: British Greggains 800 stainless steel tubes, high temperature magnesium oxide powder insulation, high-frequency resistance of wire three-tier architecture. U.S. heating rod temperature as high as 1357-1385 ° C Detect the role of the factory heating tube is used to heat the water in the liner requiring long life, high efficiency heating, leakage may not be. ①: appearance requirements: Welding good, no significant deformation, cracks, burrs. ②: Insulation: 1000V, 2S, ≥ 20MΩ ③: Voltage: 1800V, 3S, ≤ 5mA 3.Thermostat When the liner heating temperature more than 75 ° C after the temperature through the temperature control device to automatically cut off power supply when the water temperature dropped to a certain temperature, then automatically switches the power to maintain the water temperature at water heater settings to ensure that there is always water heater hot water supply. Temperature adjustment range of 30 ~ 75 ° C. 4.Thermostat If the event of thermostat failure and damageg, water temperature continues to rise, when the temperature is set to reach threshold temperature (my company as 105 ℃), limit thermostat action, cutting off power, played anti-dry, anti-over-temperature protection role. Troubleshooting question, only manual reset button so that it can continue to use it. ①: performance requirements: to limit the temperature range at 105 (-8 - +5) ℃ must be disconnected. ②: Life expectancy requirements: Power Life expectancy> 5000 times. ③: Electrical Safety; at the live terminal and the insulation between forces imposed 1800V, 50Hz, setting the exchange current of 5mA voltage sustained 1min, should be no breakdown or flashover phenomenon At the same extreme inter-sub (OFF state), imposed on 800V, 50Hz, setting the exchange current of 5mA voltage sustained 1min, should be no breakdown or flashover phenomenon. 仅供参考 |
4楼2009-03-11 14:27:32
