| 查看: 2055 | 回复: 1 | ||
[求助]
ansys垫片模拟出现错误不知道怎么解决了 已有1人参与
|
|
各位虫友，我模拟垫片在高温下压缩回弹应力分析但是出现错误，我不知道怎么办了,求你们帮我解决，小弟不胜感激！！！ *** ERROR *** CP = 32.672 TIME= 11:16:34 The unloading point of the 1th nonlinear unloading curve at temperature 100 is not on the compression curve at the same temperature for gasket material number 4. *** ERROR *** CP = 32.797 TIME= 11:17:10 The unloading point of the 1th nonlinear unloading curve at temperature 200 is not on the compression curve at the same temperature for gasket material number 4. *** ERROR *** CP = 32.875 TIME= 11:17:11 The unloading point of the 1th nonlinear unloading curve at temperature 300 is not on the compression curve at the same temperature for gasket material number 4. *** ERROR *** CP = 32.938 TIME= 11:17:12 The unloading point of the 1th nonlinear unloading curve at temperature 400 is not on the compression curve at the same temperature for gasket material number 4. *** ERROR *** CP = 33.266 TIME= 11:17:21 *CREATE cannot be used within a *DO loop. *** WARNING *** CP = 33.359 TIME= 11:17:23 No *CREATE for *END. The *END command is ignored. *** WARNING *** CP = 33.359 TIME= 11:17:23 File ansuitmp does not exist for delete. |
回复此楼» 猜你喜欢
应该是93bebmhtak前后十一个字符比较关键
已经有3人回复
-
关于代码变化问题，想知道的进来
已经有16人回复
-
fileCode有新解读？
已经有18人回复
-
这样的filecode谁见过
已经有15人回复
-
关于filecode，很负责任的告诉大家
已经有7人回复
-
【2027博士申请】纳米药物递送方向
已经有5人回复
-
关于豆爷回答的JTJC与%2F数量
已经有7人回复
-
2026国自然放榜时间
已经有3人回复
-
国基金的申报应该改成非等额制，评价高的钱多评价低的钱少，但是增加资助率
已经有7人回复
-
好奇怪的filecode
已经有4人回复
2楼2016-04-10 13:50:23
20