24小时热门版块排行榜    

查看: 876  |  回复: 7

爱吃虫得金鱼

木虫 (正式写手)

[求助] 有关于英文文献中一段话求专业大神指教 已有4人参与

With increasing temperature, heating rate and weight loss, the amount of the graphitic structure was reduced at the expense of disordered structure.这句话是指温宿升高炭黑石墨化结构减少,无定型结构增多吗?我感觉我糊涂了
回复此楼

» 猜你喜欢

» 本主题相关商家推荐: (我也要在这里推广)

已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

爱吃虫得金鱼

木虫 (正式写手)

大神们快来啊
2楼2015-07-18 15:30:54
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

Christly

禁虫 (正式写手)

感谢参与,应助指数 +1
本帖内容被屏蔽

3楼2015-07-18 15:47:41
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

kexuecheng

捐助贵宾 (初入文坛)

【答案】应助回帖

感谢参与,应助指数 +1
最好是贴出上下文才便于理解啊
4楼2015-07-18 18:29:43
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

爱吃虫得金鱼

木虫 (正式写手)

Raman spectra (Fig. 4) of studied samples confirm
presence of two bands: (i) G band at 1,590 cm-1 and (ii)
D band at 1,355 cm-1. G band confirms presence of graphitic structure and D band represents disordered structure
which is form due to the breakdown of symmetry for atoms
close to the edge of graphite sheet when formerly forbidden
transitions became possible [6].
Parameters of Raman spectra such as the position m, the
full width at half-maximum FWHM and areas I of the
G and D bands are documented in the Table 3. Raman
spectra of single-crystal graphite samples show band only
at 1,575 cm-1. Increase of temperature and heating rate of
pyrolysis leads to reduction of graphitic structure—position
of mG shift to higher value and conversely FWHMG shift to
lower value. This phenomenon was also observed andreported by Darmstadt et al. [6] who studied Raman spectra
of CB
p obtained by pyrolysis of STs at the temperature
range 420–700 C. Reduction of graphitic structure is also
confirmed by growing ratio ID/IG with increasing
temperature.
On the other hand, higher thermal treatment of CBc
cause increase of intensity of graphitic structure [5] and
position of mG decrease from about 1,600 cm-1 to around
1,575 cm-1 as the temperature increases from 27 to
2,727 C [5].
Compared to CBc Raman spectra of CBp most approaches to CB
c denoted as N375 and N774. Probably these
two carbon blacks were used as a filler during STs
manufacturing.
Linear relation (Fig. 5) was found between the intensities ID and IG and temperature of pyrolysis and weight
losses of pyrolysed sample. With increasing temperature
ration ID/IG increase and this dependence correlate with
weight loss of pyrolysis of STs
5楼2015-07-18 20:59:12
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

kexuecheng

捐助贵宾 (初入文坛)

【答案】应助回帖

你贴出的这段话只是说明温度升高与分解速率的增加会使石墨结构减少,并未说明at the expense of disordered structure
6楼2015-07-23 14:53:37
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

lzdxmc

金虫 (正式写手)

【答案】应助回帖


caominone: 金币+1, 感谢应助 2015-07-24 08:52:36
随着温度、加热速率和质量损失的增加,石墨烯中的无序结构会减少。
7楼2015-07-23 16:36:51
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

FMStation

至尊木虫 (知名作家)

【答案】应助回帖

https://www.thefreedictionary.com/expense

A loss for the sake of something gained; a sacrifice:

achieved speed at the expense of accuracy.
8楼2018-06-24 16:15:49
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖
相关版块跳转 我要订阅楼主 爱吃虫得金鱼 的主题更新
信息提示
请填处理意见