24小时热门版块排行榜    

Znn3bq.jpeg
汕头大学海洋科学接受调剂
查看: 97  |  回复: 2
当前主题已经存档。
【悬赏金币】回答本帖问题,作者dashan_612将赠送您 5 个金币

dashan_612

木虫 (正式写手)

[求助] 求一张纯Si的红外扫描图

样品在Si上面作的,首先要做的就是把Si放在那里扫描一下背底的光谱,然后在测试样品的光谱。现在我就是想要一张标准的Si的红外光谱,谢谢

» 猜你喜欢

已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

agct

金虫 (正式写手)

We then began to investigate the reliability of the supplied IR measurements. One of the authors, G. Forster, noted the transparency of the silicon crystal to IR radiation. Then, we surmised that the experimental technique and the data obtained might be suspect. Our suspicion was further reinforced when we reviewed the literature on the radiative properties of silicon crystals in the infrared region of the spectrum (see Figures 2 and 3). The steep variations in these properties, particularly in the infrared region, and the corrections needed to account for the transmittance and reflectance of silicon seem to preclude unaided and direct thermometric measurement of the silicon crystal. Another author, A. Khounsary, suggested that the silicon crystal be coated with a layer of a material opaque to infrared.



Figure 2: Normal Spectral Reflectance of Silicon [6].









Figure 3: Normal Spectral Transmittance of Silicon [6].


The IR scanner (Inframetrics model 525) used at Cornell is an "8-12" unit. This means that it is most sensitive to and suitable for (blackbody) temperature measurements in the 20-100°C range. Unfortunately, it is in this very range that a silicon crystal exhibits steep variations in its radiative properties. Therefore, if the crystal is not coated, the row data taken by the infrared scanner must be processed and interpreted to infer the actual temperatures, a laborious (and unnecessary) task in view of the strong frequency dependence of the radiative properties of silicon crystals in the spectral range of interest. On the basis of these considerations, it was then decided to run some temperature measurement tests at the ANL/Bldg. 223 laboratory. Experimental apparatus consisting of a piece of spare silicon crystal with a Peltier-effect back was set up. A thermocouple was also contact-mounted on the frontal surface of the crystal to independently measure the surface temperature at that location.

Inframetrics, Inc., was contacted to seek advice on possible opaque coatings. They suggested black vinyl electrician's tape, spray foot powder, and dye penetrant developer powder; in addition, we also considered carbon black and candle soot as acceptable candidates. These materials are all opaque to infrared radiation, have emissivities in excess of 0.9 and are readily available. The black electrician's tape and the dye penetrant developer powder (in patches) were used in our experiment. Both were equally practical, but the tape would lose its adhesiveness and peel off at higher operating temperatures. The thermocouple itself was also coated so that its temperature would also be monitored to assure proper surface contact, and thus accurate reading of the surface temperature.

Our preliminary experimental data indicated a linear correlation between the IR scanner readings and the thermocouple measurements.

As a result of these experiments, therefore, we believe that the source of the three-fold difference between our thermal-hydraulic modeling results and the Cornell IR temperature measurements are due to erroneous interpretation of the IR readings. The actual temperature rise along the surface of the three-channel crystal is about three times the values presented at the March 11 meeting. Thus, the correct value is in the 40-45°C range (assuming that the flow rate, channel and footprint dimensions, power level, etc. that are provided are accurate).

Follow-up IR calibration studies in the laboratory and accompanying analytical work verified the above conclusions. This follow-up work is detailed below.
/╲____╱\ /ˊ ` \ | ╭╮ ╭╮ | |( )( )| \/ / · \ \/ │ | – | │
2楼2008-03-08 12:54:26
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖

dashan_612

木虫 (正式写手)

没有实验扫描结果么
3楼2008-03-08 21:50:18
已阅   回复此楼   关注TA 给TA发消息 送TA红花 TA的回帖
相关版块跳转 我要订阅楼主 dashan_612 的主题更新
不应助 确定回帖应助 (注意:应助才可能被奖励,但不允许灌水,必须填写15个字符以上)
最具人气热帖推荐 [查看全部] 作者 回/看 最后发表
[考研] 食品与营养(0955)271求调剂 +13 升格阿达 2026-04-12 13/650 2026-04-14 10:25 by DdDFef31
[教师之家] 转长聘了 +5 简单化xn 2026-04-13 5/250 2026-04-14 10:22 by jiaoxg
[考研] 材料工程281还有调剂机会吗 +37 xaw. 2026-04-11 38/1900 2026-04-14 08:29 by 科宇老师
[考研] 考研调剂 +11 长弓傲 2026-04-13 12/600 2026-04-13 22:48 by pies112
[考研] B区0809 ,数一英一,290 求调剂 +3 泠潍1111 2026-04-12 4/200 2026-04-13 20:35 by 学员JpLReM
[考研] 272分材料子求调剂 +41 Loy0361 2026-04-10 53/2650 2026-04-13 14:20 by 张zhihao
[考研] 368化学求调剂 +14 wwwwabcde 2026-04-07 15/750 2026-04-13 08:36 by lhj2009
[找工作] 山东高校教师考核超级无底线,员工过不下去啦 +4 qut2026 2026-04-09 9/450 2026-04-12 00:54 by qut2026
[考研] 331求调剂 +5 王国帅 2026-04-11 5/250 2026-04-11 22:56 by 溪涧流水
[考研] 工科273调剂 +6 X1999 2026-04-09 7/350 2026-04-11 10:23 by zhq0425
[考研] 0854调剂 +8 950824he@ 2026-04-09 8/400 2026-04-11 10:11 by zhq0425
[考研] 282,求调剂 +12 jggshjkkm 2026-04-09 14/700 2026-04-11 09:39 by 猪会飞
[考研] 342电子信息专硕求调剂 +9 你让我怎么荔枝 2026-04-10 10/500 2026-04-11 08:33 by zhq0425
[考研] 314求调剂 +18 xhhdjdjsjks 2026-04-09 19/950 2026-04-10 18:53 by HPUCZ
[考研] 初试261 +3 Asht少 2026-04-10 6/300 2026-04-10 16:38 by Asht少
[考研] 296求调剂 +6 汪!?! 2026-04-08 6/300 2026-04-10 11:02 by mattzhming
[考研] 一志愿中科院105500专业总分315求调剂 +6 lallalh 2026-04-09 7/350 2026-04-09 17:51 by lallalh
[考研] 328求调剂 +17 lftmya 2026-04-07 18/900 2026-04-09 08:05 by 5268321
[考研] 求调剂,现在还能填的 +3 上岸小莹加油 2026-04-08 3/150 2026-04-08 14:30 by zhq0425
[考研] 259求调剂 +5 就爱吃土豆呀呀 2026-04-07 5/250 2026-04-07 22:40 by JourneyLucky
信息提示
请填处理意见