| 查看: 1698 | 回复: 23 | |||||||
| 【奖励】 本帖被评价18次,作者yuexu100增加金币 14.4 个 | |||||||
[资源]
TC17钛合金棒材低倍组织亮斑研究
|
|||||||
|
摘要:本文经过实验TC17钛合金在三种温度下(β+50℃、β-30℃和β-50℃)进行60%左右的变形,研究了锻造温度对棒材进行高、低倍组织及力学性能的影响。研究结果表明,相变点以上变形得到魏氏组织,低倍组织均匀无亮斑产生;相变点以下进行60%左右的锻造变形,可使α相较充分的等轴化。相变点以下30℃生产,棒材低倍组织中会出现不同程度的亮斑。经分析,亮斑为Cr元素微区分布不均匀造成的β斑,微区成分不均匀是引起TC17钛合金β斑的本质因素,锻造温度是形成β斑的主要诱发因素;相变点以下50℃生产能有效的避免低倍亮斑产生,进行适当的热处理后,其组织及性能满足标准要求。 Abstract: This text compares and analyzes the microstructure, macrostructure and the mechanical properties of the TC17 titanium bars deformed about 60% under three temperature(β+50℃、β-30℃和β-50℃). The research results shows, the deformation above the transition point could get widmanstatten microstructure, and the macrostructure is uniform and no bright speck occurred; About 60% forging deformation below the transition point can make the α phase more fully equiaxed. If produce at 30℃ below the transition point, the macrostructure of the bars will appear bright speck in various degree. After analysis, the bright speck is β patch which caused by the Cr element distributed unevenly in microzone, and the uneven composition in microzone is the essential factors causing the βpatch of TC17, and the forging temperature is the major induced factors of forming theβpatch; If produce at 50℃ below the transition point could effectively avoid the bright speck of macrostructure, after appropriate heat treatment, the microstructure and mechanical properties could meet the requirements of specification. |
» 本帖附件资源列表
-
欢迎监督和反馈:小木虫仅提供交流平台,不对该内容负责。
本内容由用户自主发布,如果其内容涉及到知识产权问题,其责任在于用户本人,如对版权有异议,请联系邮箱:xiaomuchong@tal.com - 附件 1 : TC17钛合金棒材低倍组织亮斑研究--英文.doc
2014-03-08 10:35:25, 4.4 M
» 收录本帖的淘帖专辑推荐
钛及钛合金专辑 | 科研 | 铸铁 | 科研书籍 |
» 猜你喜欢
2025冷门绝学什么时候出结果
已经有3人回复
天津工业大学郑柳春团队欢迎化学化工、高分子化学或有机合成方向的博士生和硕士生加入
已经有4人回复
康复大学泰山学者周祺惠团队招收博士研究生
已经有6人回复
AI论文写作工具:是科研加速器还是学术作弊器?
已经有3人回复
孩子确诊有中度注意力缺陷
已经有6人回复
2026博士申请-功能高分子,水凝胶方向
已经有6人回复
论文投稿,期刊推荐
已经有4人回复
硕士和导师闹得不愉快
已经有13人回复
请问2026国家基金面上项目会启动申2停1吗
已经有5人回复
同一篇文章,用不同账号投稿对编辑决定是否送审有没有影响?
已经有3人回复
» 本主题相关价值贴推荐,对您同样有帮助:
锻造工艺对大规格TC17钛合金棒材组织及性能的影响
已经有23人回复
zbhwel
专家顾问 (知名作家)
-

专家经验: +782 - MM-EPI: 7
- 应助: 1730 (讲师)
- 贵宾: 0.259
- 金币: 23085.1
- 帖子: 5197
- 在线: 1050.7小时
- 虫号: 2249580
3楼2014-03-08 20:27:33
6楼2014-03-09 09:01:48
13楼2014-03-26 18:51:58
23楼2016-05-19 21:37:16
简单回复
zjys58872楼
2014-03-08 11:37
回复
五星好评 顶一下,感谢分享!
2014-03-08 23:24
回复
五星好评 顶一下,感谢分享!
sqzhu2225楼
2014-03-09 08:49
回复
五星好评 顶一下,感谢分享!
2014-03-10 06:31
回复
五星好评 顶一下,感谢分享!
2014-03-10 08:25
回复
五星好评 顶一下,感谢分享!
ghosty009楼
2014-03-10 22:13
回复
五星好评 顶一下,感谢分享!
suncc31110楼
2014-03-11 08:11
回复
五星好评 顶一下,感谢分享!
suncc31111楼
2014-03-11 08:33
回复
顶一下,感谢分享!
qwe_jr12楼
2014-03-19 14:24
回复
五星好评 顶一下,感谢分享!
nql537941514楼
2014-03-30 00:06
回复
顶一下,感谢分享!
wjh1212121215楼
2014-04-01 16:47
回复
五星好评
fqhou16楼
2014-04-07 06:53
回复
五星好评 顶一下,感谢分享!
nature_call17楼
2014-04-10 06:15
回复
顶一下,感谢分享!
一过人18楼
2014-08-06 20:28
回复
五星好评 顶一下,感谢分享!
refenxi19楼
2014-09-10 00:22
回复
五星好评 顶一下,感谢分享!
lujinwen20楼
2014-11-12 15:10
回复
五星好评 顶一下,感谢分享!
chineneu21楼
2015-06-04 22:36
回复
五星好评 顶一下,感谢分享!
xieyjie22楼
2015-11-28 16:54
回复
五星好评 顶一下,感谢分享!
xmczlp24楼
2022-06-02 10:32
回复
五星好评 顶一下,感谢分享!













回复此楼