|
|
[资源]
分享——天然气储层工程(英文版)
"Gas Reservoir Engineering" by Djebbar Tiab
School of Petroleum and Geological Engineering, The University of Oklahoma
OkUn | 2000 | ISBN: n/a | 604 pages | PDF | 18 MB
This book presents methods for estimating reservoir fluid properties required for gas reservoir-engineering calculations; focuses on estimating original gas in place, gas reserves, and recovery factors for a variety of reservoir drive mechanisms; discusses the implementation and analysis of the four most common types of gas-well deliverability tests: flow-after-flow, single-point, isochronal, and modified isochronal tests.
The book discusses volumetric methods, including data requirements, calculation techniques, and limitations of the methods.
The theory and practical applications of pressure-transient testing in gas wells are presented.
Contents
PART 1 : INTRODUCTION
PART 2 : PHYSICAL PROPERTIES OF GAS
2.1 - PVT Diagram
2.2 - Equations Of State Or Gas Laws
2.3 - Gas Deviation Factor Z
2.4 - Correlations Of Z For Computer Programming
2.5 - Pseudocritical Properties For Gas Condensate and Wet Gas
2.6 - Compressibility Of Gas (cg)
2.7 - Viscosity Of Gases
2.8 - Formation Volume Factor
2.9 - Specific Gravity Of Gas And Gas Condensate Reservoirs
2.10 - Vapor Pressure
2.11 - Fluid Sampling Techniques
2.12 - Additional Examples
APPENDIX 2.A - Figures and Tables
PART 3 : GAS RESERVES
GAS RESERVES AND MATERIAL-BALANCE CALCULATIONS
3.1 Volumetric methods
3.2 Volumetric reservoirs
3.3 Material balance method
3.4 Numerical applications
APPENDIX 3.A - Figures and Tables
PART 4 : PRESSURE TRANSIENT TESTING OF GAS WELLS
PRESSURE TRANSIENT TESTING OF GAS WELLS
4.1 Types And Purposes Of Pressure Transient Tests
4.2 Homogeneous Reservoir Model
4.3 Complications In Actual Tests
4.4 Fundamentals Of Pressure-Transient Testing
4.5 Non-Darcy Flow
4.6 Analysis Of Gas-Well Flow Tests
4.7 Analysis Of Gas Well - Buildup Tests
4.8 Gas Well Test Analysis Using Pressure and Pressure Derivative
4.9 Numerical Applications
APPENDIX A - Figures and Tables
APPENDIX B - Fundamentals of Direct Synthesis ror Slightly Comptessible Fluids
APPENDIX C - Pseudo-Pressure Theory and Direct Synthesis
APPENDIX D - Fundamentals of Direct Synthesis for Comptessible Fluids
PART 5 : DELIVERABILITY TESTING OF GAS WELLS
DELIVERABILITY TESTING OF GAS WELLS
5.1 Types And Purposes Of Deliverability Tests
5.2 Theory of deliverability test analysis
5.3 Stabilization time
5.4 Analysis od deliverability tests
5.5 Numerical applications
APPENDIX A - Figures and Tables![分享——天然气储层工程(英文版)]()
School of Petroleum and Geological Engineering, The University of Oklahoma |
» 本帖附件资源列表
» 收录本帖的淘帖专辑推荐
» 猜你喜欢
» 本主题相关价值贴推荐,对您同样有帮助:
|