24小时热门版块排行榜

返回列表

weijiali

新虫 (正式写手)

应助: 4 (幼儿园)
金币: 31.6
散金: 25
红花: 7
帖子: 918
在线: 70.9小时
虫号: 1312519
注册: 2011-06-01
专业: 有机化学

[求助] 如何将成都有机物化所碳纳米管切短到200nm？

These cut tubes were prepared in a two-step process:
cutting and polishing. In a typical example, 10 mg of the
purified SWNT “bucky paper” (Fig. 1B) was suspended
in 40 ml of a 3:1 mixture of concentrated H2SO4/HNO3
in a 100-ml test tube and sonicated in awater bath [Cole
Palmer (Verona Hills, IL) model B3-R, 55 kHz] for 24
hours at 35° to 40°C. The resultant suspension was
then diluted with 200 ml of water, and the larger cut
SWNTs were collected on a 100-nm pore filter mem-
brane (type VCTP; Millipore) and washed with 10 mM
NaOH solution. The cut tubes were then further pol-
ished by suspension in a 4:1 mixture of concentrated
H2SO4:30% aqueous H2O2 and stirring at 70°C for 30
min. After filtering and washing again on a 100-nm pore
filter, the cut nanotubes were suspended at a density of
0.1 mg/ml in water with the aid of 0.5 weight % Triton
X-100 surfactant.
这是science上一片名为Fullerene Pipes上的文章中削短碳纳米管的介绍，不明白的问题有二：
1.上面说的55kHz不会是真的吧，应该是他那个仪器的最大频率吧？我们实验室也有一个power130w,Frequency20kHz的超声杯，我不知道要把AMPL设为百分之多少。
2.最后要加硫酸与双氧水polishing是什么意思？

我的目的是把碳纳米管切成200nm的长度来做排列，很纠结，我感觉按照文献上做也不正确，因为原料不同，我买的是成都有机物物化所的，不知道有谁做过切短的实验？我们学校做TEM很不方便，焦急中~~~

回复此楼