24小时热门版块排行榜

返回列表

【奖励】本帖被评价40次，作者zhenmafudan增加金币 33.95 个

zhenmafudan

金虫 (著名写手)

应助: 1 (幼儿园)
贵宾: 0.9
金币: 920.4
帖子: 1448
在线: 212.6小时
虫号: 276507

[资源] 我的回答审稿人问题的文书例子

引子：本人以独立作者身份投稿的文章发表了。

http://dx.doi.org/10.1016/j.jcis.2006.09.005

以下是审稿人意见和本人的回复。与大家分享。

从中可以看出，这位审稿人认真读了文章，提出很多宝贵的意见。这些意见
分布在文章的各个地方。我很诧异有人真正读了我的文章。看到这些意见，
我觉得很感激，不是因为接收文章的原因，而是这些意见能真正有助于提高
文章的质量。

从中还看出，回答审稿人问题的“技巧”。
对于回答问题，有的人就是一味反驳，却不加改进。
记得ACS Style Guide里面说，当审稿人问到问题的，哪怕是他理解错误，这
也说明作者这么写，其他读者也会理解错误，引起歧义。因此，作者就是要
修改句子，使表达不引起歧义。
因此：有时间一味反驳，还不如指出具体改进在第几页、第几段。

==============================================

Reviewers' comments:

Reviewer #3: While revising the script, it is to be suggested that author should clearly indicate the aim & scope of the study and while making conclusion, it is to be mentioned how the study is useful for the practical purposes. In addition the following are the few suggestions/comments, which may be included while revision.

1. Introduction part first para last line, author must avoid to write ambiguous statement i.e., much work is still ahead, may indicate properly.
2. Author could not demonstrate the reason why, to select the organic compound such as ethyl pyruvate for this study?
3. Experimental part: It is difficult to understand the in-situ RAIRS experiments with homemade liquid-solid RAIRS cell. More detailed information may be useful for the others those who are working in the area. Photograph of the assembled cell may be included.
4. The description given for the experimental set up (page 4) can be presented by flow diagram instead, as an ease to understand the set up.
5. Resluts Part (Page 6): "CO adlayers with identical monolayer coverages", the monolayer coverage, is it been performed with some adsorption model? Further, it was suggested that CO-saturated Pt surface, but not mentioned about the saturation experiments. Is it obtained after 60 min of CO bubbling?
6. Page 12, 2nd para: The displacement of EtPy by CCl4 flushing, is it confirmed by the EtPy peaks? If so, it has to be mentioned clearly in the para. Also in the same para, author referred for Fig. 7a and 7b but in the figures, it didn't appear, only figure 7 appeared. I feel it refers for figure 7, portion A and B, to be corrected. Similarly, in the text referred the fig 2a, 2b. etc but on the figure sheet it is mentioned as 2A, 2B .etc. to be corrected.
7. Page 14, 1st para: 'contamination of the Pt surface by corrosion of o-rings in high concentration EtPy', but the statement has not been supported by other evidence/literature.
8. Pages 14 through 17: the observed reactivity of various solvents for adsorbed CO on the Pt surface (figs 3 & 4) has to be discussed more precisely. This reviewer is unable to follow the reason why they showed different reactivity, is it principally due to the organic moieties, or due to the impurities of commercially available chemicals or a mixed effect. It has to be clearly demonstrated, however, the only experiment performed with CO/water? CCl4 would difficult to describe it in detail.
9. The author try to restrain with repeated arguments in the text e.g., page 3 para 1: It was generalized that........., also appeared on page 21 first para.
10. Captions of the figures are too long, the detailed description already given in the text, hence would not be included here. Captions should be short and crispy.

===============================================
Dear Editor,

I quite appreciate your favorite consideration and the reviewer’s insightful comments. Now I have revised the JCIS-06-247 exactly according to the reviewer’s comments, and found these comments are very helpful. I hope this revision can make my paper more acceptable. The revisions were addressed point by point below.

[general] The objective of this research was added at the beginning of the third paragraph of Introduction. How the study is useful for practical purposes was added at the end of Conclusion as one paragraph.

[1] Ambiguous statement i.e., “much work is still ahead” was deleted.

[2] Ethyl pyruvate was used here as a typical compound (containing two carbonyl groups) to demonstrate the feasibility of using our diagnosing tool to detect low-coverage CO (coming from decarbonylation of EtPy) at the liquid-solid interface. EtPy is a reactant used in liquid-phase chiral catalysis, and slight decomposition of EtPy to adsorbed CO was reported to influence the catalytic performance. In addition, by studying that, we can directly compare our results with previous studies. More details in the first paragraph of Section 3.2.

[3] The IR cell was designed according to the IR cells used by many electrochemical workers. References were added. A photo was given in the Supporting Information.

[4] A flow diagram of the experimental setup was given in the new Fig. 1.

[5] The CO adsorption experiments were performed in the same adsorption mode, by bubbling CO through a clean Pt surface in different days to achieve the same saturation coverage of CO. Initial experiments indicated that given the CO bubbling rate was 0.85 cm3/min, CO can saturate on Pt after 30-45 min. We bubble CO for 60 min to guarantee the same CO coverage. If we bubble CO for more time, or if we increase the CO flowing rate several times, the CO saturation coverage doesn’t change, indicating 60 min is already enough. A figure showing the CO uptake as a function of bubbling time was given in the Supporting Information.

[6] The displacement of EtPy by CCl4 was confirmed by the removing of EtPy peaks. The mention of Fig. 7a and 7b etc. throughout the text were all corrected.

[7] It is known that some solvents such as acetone can corrode the Viton o-ring. We saw the damage of o-ring after using high-concentration EtPy. A reference to the Viton o-ring information was given.

[8] The observed reactivity trend is due to a combination of both effects, with the accumulation of organic moieties on Pt surface during numerous flushing cycles the more important reason. A few proper sentences were added to clarity this point.

[9] The repeated arguments in the first paragraph in Section 4.3 were deleted.

[10] The too-long captions were significantly shortened.

In all, I found the reviewer’s comments are quite helpful, and I revised my paper point-by-point. Thank you and the review again for your help!
==============================================
结果：

http://dx.doi.org/10.1016/j.jcis.2006.09.005

欢迎浏览：
   Organic Chemistry on Solid Surfaces (Review)
   Z. Ma, F. Zaera*, Surface Scence Reports 61 (2006) 229-281.
   ScienceDirect TOP25 Hottest Articles in Chemistry
   http://dx.doi.org/10.1016/j.surfrep.2006.03.001
===============================================

[ Last edited by zhenmafudan on 2007-1-17 at 08:11 ]

24小时热门版块排行榜

[资源] 我的回答审稿人问题的文书例子

» 收录本帖的淘帖专辑推荐

» 猜你喜欢

» 本主题相关价值贴推荐，对您同样有帮助:

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

好贴

★★★★★ 五星级,优秀推荐

★ 一星级,一般

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

谢谢你 和大家分享。

helpful

★★★ 三星级,支持鼓励

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

★★★★★ 五星级,优秀推荐

谢谢你和大家分享。