| 查看: 478 | 回复: 0 | ||
[求助]
药典附录翻译
|
|
This chromatographic procedure is provided to demonstrate that the content of 4-epianhydrotetracycline, a degradation product of tetracycline, does not exceed the limit given in the individual monograph. EDTA Buffer— Dissolve 37.2 g of edetate disodium in 800 mL of water, adjust with ammonium hydroxide to a pH of 7.8, dilute with water to 1000 mL, and mix. Support Phase— Add 5 mL of EDTA Buffer to 10 g of acid-washed chromatographic siliceous earth for column chromatography, and mix until the siliceous earth is uniformly moistened. Test Solution— Prepare as directed in the individual monograph. Procedure— Prepare a 15-mm × 170-mm chromatographic tube with a 4-mm × 50-mm outlet by packing it, in increments, with Support Phase, firmly tamping down each increment, until the tube is filled to a height of about 10 cm. In a beaker, prepare a mixture of 1 g of acid-washed chromatographic siliceous earth for column chromatography and 1 mL of Test Solution. Transfer the mixture to the top of the column. Dry-wash the beaker with Support Phase, and transfer to the column to provide an additional 1-cm layer on top of the mixture containing the Test Solution. Within 30 minutes, pass chloroform through the column, and collect successive fractions of 5.0 mL, 5.0 mL, 10.0 mL, 10.0 mL, and 5.0 mL. Observe the column during elution, and note the appearance of two separate yellow bands. The fraction or fractions containing the first yellow band contain the anhydrotetracyclines. Discard these fractions. The fractions after the first yellow band contain the 4-epianhydrotetracycline. Determine the absorbance of each 4-epianhydrotetracycline fraction at the wavelength of maximum absorbance at about 438 nm, with a suitable spectrophotometer, diluting each fraction, if necessary, with chloroform, and using chloroform as the blank. Calculate the quantity, in mg, of 4-epianhydrotetracycline in each fraction by the formula: AVD/20.08 in which A is the absorbance, V is the volume, in mL, of the fraction taken, D is the dilution factor, if the fraction was diluted, and 20.08 is the absorptivity of 4-epianhydrotetracycline at 438 nm. From the sum of the quantities of 4-epianhydrotetracycline found in the fractions, calculate the percentage of 4-epianhydrotetracycline in relation to the tetracycline hydrochloride equivalent contained in the Test Solution. |
回复此楼» 猜你喜欢
材料求调剂 一志愿哈工大总分298分，前三科223分
已经有4人回复
-
086502化学工程342求调剂
已经有3人回复
-
求调剂
已经有9人回复
-
352分 化工与材料
已经有5人回复
-
085602 化工专硕 338分 求调剂
已经有10人回复
-
0856材料化工调剂 总分330
已经有10人回复
-
330一志愿中国海洋大学 化学工程 085602 有读博意愿 求调剂
已经有4人回复
-
一志愿哈尔滨工业大学材料与化工方向336分
已经有6人回复
-
材料求调剂一志愿哈工大324
已经有6人回复
-
085600 286分 材料求调剂
已经有4人回复
