24小时热门版块排行榜

返回列表

本帖产生 1 个翻译EPI ，点击这里进行查看

zhang-81

铁杆木虫 (正式写手)

应助: 1 (幼儿园)
金币: 6110.1
帖子: 678
在线: 391.2小时
虫号: 361844

[交流] 30金币求助5句话，禁止软件翻译

1.The values of Rs and l of the test specimen are calculated automatically, once T1, T2 and Q have been measured. Results are accurate provided that the test temperatures fall within the limits used during calibration, and that Rs does not fall outside the calibration range obtained with the reference specimens.
2. At each set of conditions, solve Eq 1 mathematically for N and Ro, using a linear regression analysis of the results for several sets of data for Rs and (T1− T2)/Q produced as a result of testing several calibration specimens. A similar series of tests carried out at the different temperatures provides
new values of N and Ro.
3. At each set of conditions, solve Eq 1 mathematically for N and Ro after measuring a pair of reference specimens to yield two sets of data for Rs and (T1−T2)/Q. Eq 1 can be used subsequently to determine Rs of the test specimen following measurement of T1, T2, and Q providing the calculated Rs falls within the calibration range corresponding to the particular pair of reference specimens in accordance with 9.2. By calibrating with additional reference specimens of different thermal resistances, several linear equations can be generated, each covering a part of the overall range
4.he heat flux transducer (HFT) is a device that will generate an electrical signal in proportion to the heat flux across it. The level of output required (sensitivity) greatly depends on the rest of the instrumentation used to read it. The overall performance of the HFT and its readout instrumentation shall be such as to meet the requirements in Section 13
5. The loading force must be transmitted to the stack through a gimball joint (2) that allows up to 5° swivel in the plane perpendicular to the axis of the stack.
Suitable insulator plate (3) separates the gimball joint from the top plate (4).

回复此楼

» 猜你喜欢

对氯苯硼酸纯化已经有3人回复
求助:我三月中下旬出站，青基依托单位怎么办？已经有12人回复
不自信的我已经有12人回复
假如你的研究生提出不合理要求已经有5人回复
所感已经有4人回复
论文终于录用啦！满足毕业条件了已经有28人回复
要不要辞职读博？已经有7人回复
北核录用已经有3人回复
实验室接单子已经有3人回复
磺酰氟产物，毕不了业了！已经有8人回复

» 抢金币啦！回帖就可以得到:

查看全部散金贴

1楼 2011-03-30 11:49:28

已阅回复此楼关注TA 给TA发消息送TA红花 TA的回帖

emmanuel0227

木虫 (著名写手)

翻译EPI: 11
应助: 0 (幼儿园)
金币: 3327.7
帖子: 1380
在线: 226.6小时
虫号: 954711

zhang-81(金币+30, 翻译EPI+1): thx 2011-03-30 15:43:05

引用回帖:

Originally posted by zhang-81 at 2011-03-30 11:49:28:
1.The values of Rs and l of the test specimen are calculated automatically, once T1, T2 and Q have been measured. Results are accurate provided that the test temperatures fall within the limits use ...

1. 一旦测试出T1, T2和Q值，就会自动计算出测试棒的Rs 和l值。加入测试温度降幅在校准限定范围内，Rs 和l值的结果是接确的， Rs不会超出对照样品得到的校准范围。
2. 在每组条件下，通过对照样品测试得到的若干组RS和 (T1− T2)/Q的数据进行线性回归分析，用Eq.1来自动计算N和RO. 同时在不同温度条件下做一组类似的测试。
3、在每组条件下，测试一对照样品从而得到两组RS和 (T1− T2)/Q的数据，然后用Eq.1来自动计算N和RO。假如计算的RS下降在校准范围以内（该校准范围根据在与9.2一致的另外一对对照样品确定的），则在进行T1，T2和Q测试之后，用Eq 1来确定RS对照样本。通过不同热阻的另外一对对照样品，能够建立若干线性方程，每个线性方程会对应总范围的一部分。
4、HFT是一种能对横截面穿过的热量产生电流型号的装置。灵敏度水平主要取决于其他数据读取仪器。HFT的总性能和它的读取器符合13节所提出的要求。
5、载荷必须传送给方向节点2装置，而该节点只容许在垂直于装置的平面上旋转5°。
配套的绝缘板使方向节点和顶部的金属板绝缘。

仅供参考。

赞一下