| 查看: 1036 | 回复: 3 | |||
| 本帖产生 1 个 翻译EPI ，点击这里进行查看 | |||
[交流]
谁有这篇SBF溶液配置的中文版本？高手？
|
|||
|
Preparation of SBF SBF is a metastable solution containing calcium and phosphate ions already supersaturated with respect to the apatite. Therefore SBF is prepared as follows.: (a) Cleaning ? Clean all the bottles including flasks, beakers etc. with dilute hydrochloric acid solution, sterilizing agent and ultra-pure water in this order ? Immerse all the bottles etc. in dilute hydrochloric acid solution for several hours. Remove the bolles from the solution and wash with tap water well. ? Immerse the bottles etc. in sterilizing liquid for overnight. Remove thme from the liquid, and washed with ultra-pure water well. ? Wash the bottles with ion-exchanged water for several times and cover their mouths with wrapping film. The bottles do not need to be dried. If the bottles would need to be dried place them in drier below 50 oC. (b) Dissolution of chemicals ? Put 750 mL(=cm3) of ultra-pure water into a 1000 mL beaker (polyethylene beaker is preferred). Stir the water and keep its temperature at 36.5 oC with magnetic stir with heater. The beaker is preferred to be placed in clean bench, to avoid dusts. ? Add each chemical given in Table III into the water until #8, one by one in the order given in Table III, after each reagent was completely dissolved. Weigh a chemical with weighing bottle. Add it in the water. Wash the remaining chemical on the weighing bottle with ultra-pure water and add the solution in the water. ? Addition of reagent #9 should be little by little with less than about 1g, in order to avoid local increase in pH of the solution. (c) Adjustment of pH ? Calibrate the pH meter with fresh standard buffer solution. ? After #9 on the order in Table III, check the temperature of the solution in the beaker, and place the electrode of pH meter in the solution. Measure its pH while the temperature is at 36.5 oC. At this point, pH of the solution is approximately 7.5. Titrate 1kmol/dm3-HCl solution with pipette to adjust the pH at 7.25 (or 7.40). ? After the adjustment of pH, transfer the solution from the beaker to a glass volumetric flask of 1000 mL. Wash the inside of the beaker with ultra-pure water several times and add the solution to the flask. ? Add ultra pure water to the solution, adjusting the total volume of the solution to 1000 mL, and the shake the flask well. Keep the flask at room temperature until its temperature should be approximately 20 oC. After cooling, add ultra-pure water again, the solution to the total volume of the solution to 1000 mL, and then shake the flask well. (d) Storage ? Rinse a polyethylene (or polystyrene) bottle of 1000 mL with a bit of the prepared solution (SBF), at least three times. Transfer the solution from the flask to the polyethylene bottle. ? Store the bottle in a refrigerator at 5-10 oC. (e) Notes ? Stability of the solution obtained must be examined. Put 50 mL of the solution in a polystyrene bottle and place it in incubator at 36.5 oC. After 2-3 days, check whether the solution has any precipitation or not. If any precipitation would be found, do not use the solution. ? Bottles in which precipitation occur must not be used for any further experiments, because some calcium phosphates would be adhered on their walls inside. A precipitation of calcium phosphate especially such as hydroxyapatite easily induces further formation of hydroxyapatite in the solution, since the simulated body fluid (SBF) is already supersaturated. Table III Reagents for preparation of SBF (pH 7.25, 1 L). Order Reagent Amount #1 NaCl Assay min. 99.5%, Nacalai tesque, Kyoto, Japan 7.996 g #2 NaHCO3 Assay (after drying) min. 99.5-100.3%, Nacalai tesque, Kyoto, Japan 0.350 g #3 KCl Assay min. 99.5%, Nacalai tesque, Kyoto, Japan 0.224 g #4 K2HPO4?3H2O Assay min. 99.0%, Nacalai tesque, Kyoto, Japan 0.228 g #5 MgCl2?6H2O Assay min. 98.0%, Nacalai tesque, Kyoto, Japan 0.305 g #6 1 kmol/m3 HCl 87.28 mL of 35,4% HCl is diluted to 1000 mL with volumetric flask 40 cm3 #7 CaCl2 Assay min. 95.0%, Nacalai tesque, Kyoto, Japan Use after drying at 120 oC for more than 12 hours 0.278 g #8 Na2SO4 Assay min. 99.0%, Nacalai tesque, Kyoto, Japan 0.071 g #9 (CH2OH)3CNH2 Assay (after drying) min. 99.9%, Nacalai tesque, Kyoto, Japan 6.057 g #10 1 kmol/m3 HCl See above Appropriate amount for adjusting pH |
回复此楼» 猜你喜欢
265求调剂
已经有4人回复
-
085700资源与环境308求调剂
已经有6人回复
-
一志愿吉林大学材料学硕321求调剂
已经有12人回复
-
286分人工智能专业请求调剂愿意跨考！
已经有3人回复
-
329求调剂
已经有5人回复
-
申请回稿延期一个月，编辑同意了。但系统上的时间没变，给编辑又写邮件了，没回复
已经有4人回复
-
材料学硕318求调剂
已经有5人回复
-
一志愿中国海洋大学，生物学，301分，求调剂
已经有6人回复
-
081700化工学硕调剂
已经有3人回复
-
一志愿苏州大学材料求调剂，总分315（英一）
已经有3人回复
» 抢金币啦！回帖就可以得到:
-
持续创业者，A8离异男征婚，事业遇到瓶颈，寻找创业生活伴侣
+1/469
-
福建农林大学材料工程学院高分子材料课题组招生
+1/99
-
双一流南京医科大学招计算机、AI、统计、生物信息等方向26年9月入学博士
+1/85
-
海南大学化工院生物质定向转化课题组招收博士/硕士，2026年9月入学
+1/84
-
福建师范大学招收2026年化学、材料硕士3-4名
+1/80
-
西北大学化学与材料科学学院博士招生（还有两个名额，3月30日截至）
+1/64
-
2026年重庆工商大学管理科学与工程专业学术硕士招生调剂，风景总在柳暗花明处
+1/35
-
哈工大郑州高等研究院刘绍琴与查正宝教授课题组诚招合成生物学背景相关的优秀人才加盟
+1/34
-
上海交大化院功能大分子团队招2026年硕士、联培、博士后
+1/32
-
南京理工大学优青团队招聘副教授、博士后、博士、硕士生（化学、催化方向）
+1/31
-
上海交通大学机械与动力工程学院博士后招聘
+3/23
-
西南某211招27届博士
+1/17
-
南京医科大学-膜蛋白结构与功能课题组-招收2026级博士研究生
+1/10
-
南京林业大学有机功能分子实验室博士生招生启事
+1/8
-
青岛科技大学化工学院院士团队2026年拟招收全日制博士研究生1名
+1/7
-
福建师范大学化学与材料学院杜克钊团队博士招生
+2/6
-
北京高校副校长团队招收机械类，环境类学硕和专硕
+1/5
-
博后即将出站，求稳定的教职
+1/3
-
MTI 380调剂
+1/3
-
北京高校副校长团队招收机械类，环境类学硕和专硕
+1/1
2楼2011-03-06 17:23:24
zhao9277(金币+5, 翻译EPI+1): 谢谢，但是好像打不开呢 2011-03-06 17:39:22
3楼2011-03-06 17:30:31
4楼2011-03-06 17:57:39
