| 查看: 384 | 回复: 4 | |||
| 当前主题已经存档。 | |||
| 本帖产生 1 个 翻译EPI ，点击这里进行查看 | |||
[交流]
求助高手
|
|||
|
从图中可看出三种样品都形成了孔，同时从表3-1中可以看出，纯样品比表面积最小。从光催化活性测试中也发现a的活性较另外两个更小，说明比表面积对光催化活性有影响；b的比表面积最大，c次之，但吸附效果应该越好，光催化活性越好；但光催化活性测试表明，共掺杂的光催化活性最高，这说明比表面积只是影响光催化活性的重要因素之一，而且进一步说明了S、N共掺杂是协同作用并且这种协同作用在本实验中起主导作用。 急用！谢谢！ |
回复此楼» 猜你喜欢
课题组招2027级博士 上海工程技术大学 激光智能制造方向
已经有4人回复
-
现代”学阀”该如何界定
已经有8人回复
-
上海工程技术大学 激光智能制造课题组 2027级博士研究生招生
已经有3人回复
-
实名举报：华南理工大学物理与光电学院副院长李志远婚内两次出轨女学生（博士）
已经有16人回复
-
上海工程技术大学激光智能制造课题组｜2027级博士研究生招生公告
已经有11人回复
-
上海工程技术大学激光智能制造课题组招收博士研究生
已经有10人回复
-
申博发邮件
已经有11人回复
-
各位大神，目前国内有哪些比较好用的逆合成软件？
已经有12人回复
-
我的奶奶
已经有3人回复
-
国社科系统bug了，是不是要放榜了？
已经有9人回复
2楼2010-04-13 12:44:07
resonant
木虫 (正式写手)
独自为政
- 翻译EPI: 1
- 应助: 0 (幼儿园)
- 贵宾: 0.063
- 金币: 3859.3
- 帖子: 594
- 在线: 44.5小时
- 虫号: 113887
- 注册: 2005-11-23
- 专业: 光学
★ ★ ★
sirljz(金币+3):谢谢交流 2010-04-13 13:57
yujiao8819(金币+4, 翻译EPI+1):谢谢 2010-04-14 09:36
sirljz(金币+3):谢谢交流 2010-04-13 13:57
yujiao8819(金币+4, 翻译EPI+1):谢谢 2010-04-14 09:36
没看到你的样品和实验，只能臆测。将就一下 你的中文表述好像不很通顺... As shown in Figure X, three samples all formed hole structure, while according to Table 3-1, pure sample obtained the minimal specific area. photocatalysis activity assay suggested sample a is less active than the other two, which indicated specific area exerts effects on catalytic activity- sample b has a maximal specific area, sample c takes second place...感觉不对劲，停止翻译... [ Last edited by resonant on 2010-4-13 at 20:32 ] |
3楼2010-04-13 13:14:38
lastzealot
新虫 (著名写手)
【乱世的奸雄】
- 翻译EPI: 10
- 应助: 87 (初中生)
- 金币: 2676.4
- 散金: 876
- 红花: 24
- 帖子: 2921
- 在线: 212.6小时
- 虫号: 730090
- 注册: 2009-03-24
- 性别: GG
- 专业: 高分子材料结构与性能
|
It is clearly observed that holes have been formed in all of the three samples. At the same time, from Fig. 3-1, the specific surface area of the pure sample is the smallest. It is also seen from the characterization of photocatalytic activity that the activity of sample A is smaller that the other two, which indicates the specific surface area has some influence on the photocatalytic activity. The specific surface area of B is the largest followed by that of C, so the adsorption should be better, and the photocatalytic activity should be better. However, the characterization of photocatalytic activity shows that the catalytic activity of codoping is the upmost one. This indicates that the specific surface area is only one important factor of photocatalytic activity and the codoping of S and N has some synergistic effect which plays the dominant role in the study. |
4楼2010-04-13 14:01:36
lastzealot
新虫 (著名写手)
【乱世的奸雄】
- 翻译EPI: 10
- 应助: 87 (初中生)
- 金币: 2676.4
- 散金: 876
- 红花: 24
- 帖子: 2921
- 在线: 212.6小时
- 虫号: 730090
- 注册: 2009-03-24
- 性别: GG
- 专业: 高分子材料结构与性能
yujiao8819(金币+16):谢谢 2010-04-14 09:37
| It is clearly observed that holes have been formed in all of the three samples. At the same time, from Fig. 3-1, the specific surface area of the pure sample is the smallest. It is also seen from the characterization of photocatalytic activity that the activity of sample A is smaller that the other two, which indicates the specific surface area has some influence on the photocatalytic activity. The specific surface area of B is the largest followed by that of C, so the adsorption should be better, and the photocatalytic activity should be better. However, the characterization of photocatalytic activity shows that the catalytic activity of codoping is the upmost one. This indicates that the specific surface area is only one important factor of photocatalytic activity and the codoping of S and N has some synergistic effect which plays the dominant role in the study. |
5楼2010-04-13 19:41:20