| 查看: 386 | 回复: 3 | |||
| 当前主题已经存档。 | |||
zhangxin1862金虫 (正式写手)
|
[交流]
【求助】天然橡胶/丁苯橡胶电缆料有朋友作吗
|
||
| 天然橡胶/丁苯橡胶电缆料有朋友作吗？有朋友做交流一下 |
回复此楼» 猜你喜欢
一志愿双一流机械285分求调剂
已经有5人回复
-
一志愿：西北大学，英一数一408-284分求调剂
已经有4人回复
-
291求调剂
已经有5人回复
-
求调剂
已经有3人回复
-
化学0703 调剂 306分 一志愿211
已经有5人回复
-
275求调剂
已经有16人回复
-
调剂310
已经有11人回复
-
300求调剂，材料科学英一数二
已经有9人回复
-
296求调剂
已经有3人回复
-
一志愿南昌大学324求调剂
已经有3人回复
旭日东升
铁杆木虫 (著名写手)
- 应助: 1 (幼儿园)
- 金币: 7499.3
- 红花: 2
- 帖子: 1478
- 在线: 208.3小时
- 虫号: 472498
- 注册: 2007-12-04
- 性别: GG
- 专业: 高分子合成化学
2楼2009-06-30 20:09:31
zhangxin1862
金虫 (正式写手)
- 应助: 0 (幼儿园)
- 金币: 826.8
- 散金: 50
- 红花: 4
- 帖子: 424
- 在线: 199.6小时
- 虫号: 438842
- 注册: 2007-09-30
- 性别: GG
- 专业: 应用高分子化学与物理
3楼2009-07-02 10:47:11
★
小木虫(金币+0.5):给个红包，谢谢回帖交流
小木虫(金币+0.5):给个红包，谢谢回帖交流
|
Role of polymer–clay interactions and nano-clay dispersion on the viscoelastic response of supercritical CO2 dispersed polyvinylmethylether (PVME)–Clay nanocomposites References and further reading may be available for this article. To view references and further reading you must purchase this article. Mihai Manitiua, Steven Horsch1, a, Esin Gulari2, a and Rangaramanujam M. Kannan, a, aWayne State University, Chemical Engineering and Materials Science, Detroit, MI 48202, USA Received 1 April 2009; revised 11 May 2009; accepted 19 May 2009. Available online 27 May 2009. Abstract Clay dispersion and polymer–clay interactions play a key role in producing property enhancements in nanocomposites; yet characterizing them in complex polymer–clay systems is often a challenge. Rheology can offer insights into clay dispersion and clay–polymer interactions. We have investigated the viscoelastic response for a series of supercritical CO2 (scCO2) processed polyvinylmethylether (PVME)/clay nanocomposites with varying polymer–clay interactions and nano-clay dispersion. PVME is used in this study because it is highly swellable in scCO2, thereby enabling processing of PVME/clay mixtures without the presence of a co-solvent. Since PVME and natural clay are water-soluble, highly dispersed PVME-clay nanocomposites were prepared using water, followed by lyophilization in the presence of polymer. In this ‘weakly interacting’, but highly dispersed systems, with clay loadings above the percolation threshold, terminal behavior was observed in the linear viscoelastic moduli (i.e. no low frequency plateau is observed). When the nanocomposites were processed in scCO2, with 15 wt% of 30B and I.30P, the WAXD patterns of the resultant nanocomposites were largely comparable, indicating partial dispersion, with intercalation peaks. However, the rheology of these two nanocomposites were significantly different despite similar inorganic volume loading (4 vol%). Even with less dispersion compared to the water-based system, the low-frequency moduli were significantly more enhanced, accompanied by a plateau, and a cross-over frequency shift. Neglecting the small differences in the actual clay content between these clays (4–5 vol% of inorganic matter), this suggests that rheology may be sensitive to strong interactions between the clay surfactant and the polymer. Therefore, polymer–clay interactions and clay–clay interactions may both be important in the ability to sustain a “so-called” percolated network, rather than just clay dispersion. Graphical abstract Full-size image (26K) Keywords: Supercritical CO2 processing; Dispersed polymer–clay nanocomposites; Rheology Article Outline 1. Introduction 2. Experimental methods 2.1. Materials 2.2. scCO2 Processing 2.3. Nanocomposite formation via scCO2 processing 2.4. Nanocomposite formation via solution cast freeze drying 2.5. Wide-angle X-ray diffraction (WAXD) 2.6. Rheology 2.7. Thermogravimetric analysis (TGA) 3. Results and discussion 3.1. Determination of clay mass fraction in organophilic nano-clays 3.2. Role of substantial nano-clay dispersion with ‘weak’ polymer–clay interactions 3.2.1. PVME versus PEO 3.2.2. PVME – highly dispersed versus scCO2-processed 3.3. Role of polymer–clay interactions with comparable levels of intercalation 3.3.1. PVME-30B nanocomposite 3.3.2. PVME-I.30P nanocomposite 4. Conclusions Acknowledgements Appendix. Appendix References Fig. 1. TGA analysis of pure nano-clays, Cloisite Na+, Cloisite 30B and Nanocor I.30P. The 6% reduction in weight of Cloisite Na+ is attributed to the evaporation of water. Cloisite 30B organophilic nano-clay contains 14 wt% ammonium salt. Nanocor I.30P organophilic nano-clay contains 31 wt% ammonium salt. View Within Article -------------------------------------------------------------------------------- Fig. 2. (a) WAXD of sample Cloisite Na+/PEO reveals the sample is intercalated as evident by the significant shifting of the d001 diffraction peak and the presence of higher order peaks (d002).(b) WAXD of PVME/Na+ samples 15-NA, 15NA-S, and as received Cloisite Na+. Sample 15-NA has a weak diffraction peak thought to be the result of a disordered intercalated structure and sample 15NA-S is delaminated as evident by the lack of a coherent diffraction pattern. View Within Article |
4楼2009-07-21 14:03:32
