24小时热门版块排行榜

>论坛更新日志 (2769)
>导师招生 (174)
>文献求助 (124)
>虫友互识 (96)
>考博 (64)
>招聘信息布告栏 (53)
>休闲灌水 (51)
>论文投稿 (46)
>硕博家园 (45)
>博后之家 (32)
>基金申请 (22)
>教师之家 (19)
>考研 (18)
>找工作 (16)
>公派出国 (13)
>有机资源 (12)

返回列表

左手不离2014

铁杆木虫 (正式写手)

应助: 1 (幼儿园)
金币: 5894.3
散金: 15
红花: 2
帖子: 580
在线: 67.1小时
虫号: 4009186
注册: 2015-08-06
性别: GG
专业: 多相流热物理学

[求助] 非定常计算中对称面设置问题已有1人参与

ERROR #002100013 has occurred in subroutine Chk_Splane.          |
| Message:                                                          |
| The symmetry boundary condition requires that the boundary patch |
| mesh faces form a plane or axis.  However, face set  25 in the    |
| symmetry boundary patch                                           |
|                                                                   |
|  r_sym                                                          |
|                                                                   |
| is not in a strict plane, which means that at least one of its    |
| faces is not parallel to the others.  To make the solver run    |
| you can do one of the following:                                  |
|                                                                   |
|  (1) Make sure that this symmetry boundary patch is in a plane or  |
|    axis by checking and regenerating the mesh.                |
|  (2) If the symmetry boundary patch is an axis rather than a    |
|    plane, change the tolerance of the degeneracy check by       |
|    increasing the value of the Solver Expert Parameter          |
|    'degeneracy check tolerance' (the default value is 1.e-4). |
|  (3) Increase the value of the Solver Expert Parameter          |
|    'vector parallel tolerance' (the default value is 1 deg.). |
|    Note that the accuracy of the symmetry condition may decrease |
|    as the tolerance is increased.  This is because the tolerance |
|    is the number of degrees that a mesh face normal is allowed |
|    to deviate from the average normal for the entire face set.

回复此楼