| 查看: 10961 | 回复: 1 | |||
[交流]
ansys后处理分析时闪退问题 已有1人参与
|
|
ansys瞬态分析计算完成后显示solution is done并且好好的，当进入后处理时就闪退了。 查看了error文件里面 A reference force value times the tolerance is used by the Newton-Raphson method for checking convergence. The calculated reference FORCE CONVERGENCE VALUE = 0 is less than a threshold. This threshold defaults to 1.0-2 or is specified as MINREF on the CNVTOL command. Check results carefully. yuanhui 13:12:25 *** WARNING *** SUPPRESSED MESSAGE CP = 14.711 TIME= 12:00:40 A reference force value times the tolerance is used by the Newton-Raphson method for checking convergence. The calculated reference FORCE CONVERGENCE VALUE = 0 is less than a threshold. This threshold defaults to 1.0-2 or is specified as MINREF on the CNVTOL command. Check results carefully. *** ERROR *** CP = 5956.570 TIME= 12:58:43 An unexpected error ( SIG$SEGV ) has occurred... ANSYS internal data has been corrupted. ANSYS is unable to recover and will terminate. Previously saved files are unaffected. Please send the data leading to this operation to your technical support provider, as this will allow ANSYS, Inc to improve the program. 只有最后一个error就是在进入/post26后出现的，其余都是warning。为什么计算收敛完成了还会出现这种情况呢？ |
回复此楼
shgao20
专家顾问 (职业作家)
-
专家经验: +809 - 仿真EPI: 1
- 应助: 1311 (讲师)
- 金币: 13381.4
- 红花: 267
- 帖子: 3531
- 在线: 473.4小时
- 虫号: 3644138
- 注册: 2015-01-14
- 专业: 动力学与控制
- 管辖: 仿真模拟
2楼2018-10-19 07:49:43