| 查看: 314 | 回复: 2 | |||
| 当前主题已经存档。 | |||
[交流]
【求助】PVP K-30的检测方法。
|
|||
|
如何检测PVP,k-30的含量呢,要求简单点,仪器检测在小公司很难执行。 最好有滴定分析。谢谢各位达人。 |
» 猜你喜欢
2019年青年基金涵评意见,大家看看几个A,几个B?
已经有8人回复
不应该看fileCode
已经有6人回复
好奇怪的filecode
已经有6人回复
FileCode能看出啥?
已经有21人回复
长年满屏的广告,版主太不责任了。基金也等的急
已经有4人回复
filecode
已经有15人回复
关于Filecode分析方法
已经有4人回复
应该是93bebmhtak前后十一个字符比较关键
已经有35人回复
职称评审,求友友推荐见刊最快的期刊
已经有4人回复
奇怪,两个人的filecode固定段从头到尾一模一样
已经有10人回复
xiaozhu629
铁杆木虫 (小有名气)
Mike
- 应助: 0 (幼儿园)
- 金币: 5628.7
- 红花: 1
- 帖子: 205
- 在线: 36.3小时
- 虫号: 273090
- 注册: 2006-08-19
- 性别: GG
- 专业: 样品前处理方法与技术
★
clkk216(金币+1,VIP+0):3Q~~! 辛苦了~~!
clkk216(金币+1,VIP+0):3Q~~! 辛苦了~~!
|
ASSAY for Povidone K30 from BP Place 100.0 mg of the substance to be examined (m mg) in a combustion flask, add 5 g of a mixture of 1 g of copper sulphate R, 1 g of titanium dioxide R and 33 g of dipotassium sulphate R, and 3 glass beads. Wash any adhering particles from the neck into the flask with a small quantity of water R. Add 7 ml of sulphuric acid R, allowing it to run down the sides of the flask, and mix the contents by rotation. Close the mouth of the flask loosely, for example by means of a glass bulb with a short stem, to avoid excessive loss of sulphuric acid. Heat gradually at first, then increase the temperature until there is vigorous boiling with condensation of sulphuric acid in the neck of the flask; precautions are to be taken to prevent the upper part of the flask from becoming overheated. Continue the heating for 45 min. Cool, dissolve the solid material by cautiously adding to the mixture 70 ml of water R, cool again and place in a steam-distillation apparatus. Add 30 ml of strong sodium hydroxide solution R through the funnel, rinse cautiously the funnel with 10 ml of water R and distil immediately by passing steam through the mixture. Collect about 80-100 ml of distillate in a mixture of 30 ml of a 40 g/l solution of boric acid R and 3 drops of bromocresol green-methyl red solution R and enough water R to cover the tip of the condenser. Towards the end of the distillation lower the receiver so that the tip of the condenser is above the surface of the acid solution and rinse the end part of the condenser with a small quantity of water R. Titrate the distillate with 0.025 M sulphuric acid until the colour of the solution changes from green through pale greyish-blue to pale greyish-red-purple (n1 ml of 0.025 M sulphuric acid). Repeat the test using about 100.0 mg of glucose R in place of the substance to be examined (n2 ml of 0.025 M sulphuric acid). 是凯式定氮法,主要是玻璃仪器以及滴定,应该比较简单,另外也可参考ChP2005 921页 《聚维酮 K30》 |
2楼2008-12-25 12:19:21
3楼2008-12-25 16:44:42










回复此楼